Pioneer AVIC-F310BT Manual de instalación - Página 5

Navegue en línea o descargue pdf Manual de instalación para Receptor para automóvil Pioneer AVIC-F310BT. Pioneer AVIC-F310BT 5 páginas. Gps navigation audio system
También para Pioneer AVIC-F310BT: Manual de inicio rápido (2 páginas)

Imprimir página

Connecting the System

Precautions before

connecting the system

CAUTION

! If you decide to perform the installation

yourself, and have special training and ex-

perience in the mobile electronics instal-

lations, please carefully follow all of the

steps in the installation manual.

! Secure all wiring with cable clamps or

electrical tape. Do not allow any bare wir-

ing to remain exposed.

! Do not directly connect the yellow lead of

this product to the vehicle battery. If the

lead is directly connected to the battery,

engine vibration may eventually cause

the insulation to fail at the point where

the wire passes from the passenger com-

partment into the engine compartment. If

the yellow lead's insulation tears as a re-

sult of contact with metal parts, short-cir-

cuiting can occur, resulting in

considerable danger.

! It is extremely dangerous to allow the

cables to become wound around the steer-

ing column or gearstick. Be sure to install

this product, its cables, and wiring away

in such a way that they will not obstruct

or hinder driving.

! Make sure that the cables and wires are

routed and secured so they will not inter-

fere with or become caught in any of the

vehicle's moving parts, especially the

steering wheel, gearstick, handbrake, slid-

ing seat tracks, doors, or any of the vehi-

cle's controls.

! Do not route wires where they will be ex-

posed to high temperatures. If the insula-

tion heats up, wires may become

damaged, resulting in a short circuit or

malfunction and permanent damage to

the product.

! Do not cut the GPS aerial cable to shorten

it or use an extension to make it longer.

Altering the aerial cable could result in a

short circuit or malfunction.

! Do not shorten any leads. If you do, the

protection circuit (fuse holder, fuse resis-

tor or filter, etc.) may fail to work properly.

! Never feed power to other electronic pro-

ducts by cutting the insulation of the

power supply lead of the navigation sys-

tem and tapping into the lead. The current

capacity of the lead will be exceeded,

causing overheating.

! The black lead is earth. Please earth this

lead separately from the earth of high-cur-

rent products such as power amps. Do not

earth more than one product together

with the earth from another product. For

example, you must separately earth any

amp unit away from the earth of this navi-

gation system. Connecting earths to-

gether can cause a fire and/or damage the

products if their earths became

detached.

Section

Engb