Din Sync VCF303 Manual del usuario - Página 9
Navegue en línea o descargue pdf Manual del usuario para Equipo de música Din Sync VCF303. Din Sync VCF303 14 páginas. Eurorack filter module
Imprimir página.
.
Patch Examples
Basic Acid Patch
additional modules needed, OSC303 (or other oscillator), Sequencer, ADSR, VCA, Clock
source.
Connect Sequencer cv out to OSC303 cv in
Connect OSC303 square or saw output to VCF303 input
Connect VCF303 output to vca signal in
Mult clock pulse to VCF303 ENV TRIG, Sequencer clock in and ADSR trigger in
Connect ADSR output to vca cv in
Advanced Acid Patch
additional modules needed, OSC303 (or other oscillator), Makenoise, Rene, Brains+Pressure
points (or equivalents), ADSR, VCA with two cv inputs or VCA with one cv input and a DC
coupled mixer, attenuator or gain amplifier (optional), Clock source.
Connect Rene QCV to OSC303 cv in
Set Rene to snake mode (X FUN page)
Set Rene glide on (X FUN PAGE)
Connect Pressure Points top row output to Rene XMOD
Connect Pressure Points second row output to VCF303 AC TRIG
Optionally connect Pressure Points bottom row output to VCF303 CV (if you want sequenced
cutoff)
Connect OSC303 square or saw output to VCF303 input
Connect VCF303 output to vca signal in
Mult clock pulse to VCF303 ENV TRIG in, Rene XCLK, Brains clock in and ADSR trigger in
Connect ADSR output to vca cv in 1 (if you only have a single cv input on your VCA then
connect ADSR output to DC coupled mixer in and connect mixer output to vca cv in)
Connect VCF303 ACcent out to vca cv in 2 (if you only have a single cv input on your VCA then
connect VCF303 ACcent output to DC coupled mixer in)
Depending on the sensitivity of your vca you may wish to place an attenuator or gain amplifier
between the VCF303 ACcent out and vca.
Use the top row of Pressure Points to control sequencer glides
Use the middle row of Pressure Points to control accents
Use the bottom row of Pressure Points to control frequency cutoff (if connected)