Pioneer DEH-3200UB Manual de instrucciones - Página 14
Navegue en línea o descargue pdf Manual de instrucciones para Receptor para automóvil Pioneer DEH-3200UB. Pioneer DEH-3200UB 31 páginas. Cd rds receiver
También para Pioneer DEH-3200UB: Manual de instalación (6 páginas), Manual de instrucciones (28 páginas), Manual de instrucciones (29 páginas), Manual de instalación (8 páginas)
Imprimir página
Section
riD (
Operating this unit
This unit is equipped with a subwoofer output which
can be turned on or off.
Press
M.e.
to display the setting mode.
.L
Turn
M.e.
to select the deSIred setting.
Normal (normal phase)-Reverse (reverse
phase)--OFF (subwoofer off)
~
Press
M.e.
to confirm the selection.
When the subwoofer output is on. you can adjust the
cut-off frequency and the output level of the subwoo-
fer,
Only frequencies lower than those
In
the selected
range are outputted from the subwoofer,
~
Press
M.e.
to display the setting mode.
T
Press
M.e.
to cycle between cut-off frequency and
output level of subwoofer.
Ll.
Press
M.e.
to switch to cut-off frequency and then
tum
M.e.
to select cut-off frequency,
50Hz-63Hz-BOHz-100Hz-125Hz
~
Press
M.e.
to switch to output level and then tu rn
M.e.
to adjust output level.
Adjustment range: +6
to -24
When you do not want low sounds from the subwoo-
fer output frequency range to play from the front or
rear speakers, turn on the HPF (high pass filter) Only
frequencies higher than those in the selected range
are output from the front or rear speakers,
Press
M.e.
to display the setting mode.
T
Turn
M.e.
to select cut-off frequency.
OFF (0ff)-50Hz-63Hz-80Hz-100Hz-125Hz
IT
Press
M.e.
to confirm the selectton.
~_
Press
M.e.
to display the setting mode,
.£
Turn
M.e.
to adjust the level.
Adjustment range: 0 to +6
~_
Press
M.e.
to confirm the selection.
En
J
5LA
(Source level adjustment) lets you adjust the vo-
lume level of each source to prevent radical changes
In volume when SWitching between sources,
•
When selecting FM as the source, you cannot
switch to SLA.
Settings are based on the FM volume level which
remains unchanged.
Before adjusting source levels, compare the FM
volume level 'Nith the level of the source you Wish
to adjUSt.
•
The AM volume level can also be adjusted With
source level adjustments.
1
Press
M.e.
to display the setting mode,
T
Turn
M.e.
to adjust the source volume,
Adjustment range: +4 to-4
r3
Press
M.e.
to confirm the selection,
•
Note
Operation is complete even if the menu is can-
celled before being confirmed.
[!J
Initial Settings
1
Press SRClOFF and hold until the unit
turns off.
2
Press M.e. and hold until the initial set-
ting menu appears in the display.
3
Turn M.e. to select the initial setting.
After selecting, perform the following proce-
dures to set the initial setting.
Ll.
Press
M.e.
to display the setting mode,
!1...
Press
M.e.
to select the segment of the clock dis-
play you wish to set.
Hour-Minute
As you select segments of the clock display, the
selected segment flashes,
•3
Turn
M.e.
to adjust the clock.
'1
Press
M.e.
to turn the clock display on
01-
off,
Activate this setting when uSing aUXiliary device con-
nected to thiS unit.
Press
M.e.
to tu rn
AUX
on or oft.