Pioneer MXT-X176UI Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Receptor para automóvil Pioneer MXT-X176UI. Pioneer MXT-X176UI 24 páginas.

Imprimir página

Preparing the remote control

Remove the insulation sheet before use.

How to replace the battery

Insert the CR2025 (3 V) battery with the plus (+) and

minus (–) poles orientated properly.

WARNING

• Keep the battery out of the reach of children. Should the battery be swallowed, consult a doctor

immediately.

• Do not expose the battery or remote control to excessive heat such as direct sunlight or fire.

CAUTION

• There is a potential danger of explosion if the battery is incorrectly replaced. When replacing the

battery, replace it with the same type.

• Do not handle or store the battery with metallic tools or objects.

• If the battery leaks, remove the battery and wipe the remote control completely clean. Then install a

new battery.

• When disposing of used batteries, compliance with governmental regulations or environmental

institutions' rules that apply in your country/area must be followed that pertain to any special

handling needed for disposal.

Important

• Do not store the remote control in high temperatures or direct sunlight.

• Do not let the remote control fall onto the floor, where it may become jammed under the brake or

accelerator pedal.

Setup menu

When you turn the ignition switch to ON after installation, [SET UP :YES] appears in the

display.

Press the M.C. dial.

The setup menu disappears after 30 seconds of no operation. If you prefer not to set

at this time, turn the M.C. dial to select [NO], then press to confirm.

Turn the M.C. dial to select the options, then press to confirm.

To proceed to the next menu option, you need to confirm your selection.

Menu Item

Description

CLOCK SET

Set the clock.

FM STEP

Select the FM tuning step from 100 kHz or 50 kHz.

[100], [50]

MW STEP

Select the MW tuning step from 10 kHz or 9 kHz.

[10], [9]

[QUIT :YES] appears when all the settings have been made.

To return to the first item of the setup menu, turn the M.C. dial to select [QUIT :NO],

then press to confirm.

Press the M.C. dial to confirm the settings.

NOTES

• You can cancel the menu setting by pressing SRC/OFF.

• These settings can be made at any time from the SYSTEM settings (page 14) and INITIAL settings

(page 5).

Canceling the demonstration display (DEMO OFF)

Press the M.C. dial to display the main menu.

Turn the M.C. dial to select [SYSTEM], then press to confirm.

Turn the M.C. dial to select [DEMO OFF], then press to confirm.

Turn the M.C. dial to select [YES], then press to confirm.

INITIAL settings

Press and hold SRC/OFF until the unit turns off.

Press the M.C. dial to display the main menu.

Turn the M.C. dial to select [INITIAL], then press to confirm.

Turn the M.C. dial to select an option, then press to confirm.

NOTE

The options vary depending on the unit.