Pioneer XDV-P650 Manual de instalación - Página 10

Navegue en línea o descargue pdf Manual de instalación para Receptor para automóvil Pioneer XDV-P650. Pioneer XDV-P650 38 páginas. Xdv-p650

Imprimir página

Installation

Note:

• Before making a final installation of the unit,

temporarily connect the wiring to confirm that the

connections are correct and the system works

properly.

• Use only the parts included with the unit to

ensure proper installation. The use of unautho-

rized parts can cause malfunctions.

• Consult with your nearest dealer if installation

requires the drilling of holes or other modifica-

tions of the vehicle.

• Install the unit where it does not get in the dri-

ver's way and cannot injure the passenger if there

is a sudden stop, like an emergency stop.

• Do not place the display (sold separately) in a

position where it will impede the driver's visibili-

ty or affect the operation of your vehicle's air

bags.

• The semiconductor laser will be damaged if it

overheats, so don't install the unit anywhere hot

— for instance, near a heater outlet.

• If installation angle exceeds 30° from horizontal,

the unit might not give its optimum performance.

• When installing, to ensure proper heat dispersal

when using this unit, make sure you leave ample

space behind the rear panel and wrap any loose

cables so they are not blocking the vents.

• When mounting the hide-away unit, make sure

none of the leads are trapped between the hide-

away unit and the surrounding metalwork or fit-

tings.

• Do not mount the hide-away unit near the heater

outlet, where it would be affected by heat, or near

the doors, where rainwater might splash onto it.

• Before drilling any mounting holes always check

behind where you want to drill the holes. Do not

drill into the gas line, brake line, electrical wiring

or other important parts.

• If the hide-away unit is installed in the passenger

compartment, anchor it securely so it does not

break free while the car is moving, and cause

injury or an accident.

• If the hide-away unit is installed under a front

seat, make sure it does not obstruct seat move-

ment. Route all leads and cords carefully around

the sliding mechanism so they do not get caught

or pinched in the mechanism and cause a short

circuit.

MODE Switch Setting

Before installing, use a pen tip or other thin,

pointed instrument to set the MODE Switch to

the appropriate position for the component

you are using it with.

STAND ALONE

IP BUS

Installing the hide-away unit

Mounting with Velcro Tape

Thoroughly wipe off the surface

before affixing the velcro tape.

Car mat or chassis

Hide-away unit

Velcro tape

(large) (hard)

Velcro tape

(large) (soft)