Pioneer AVH-P3200BT Manual de instalación - Página 11
Navegue en línea o descargue pdf Manual de instalación para Receptor Pioneer AVH-P3200BT. Pioneer AVH-P3200BT 40 páginas. Dvd, rds, av receiver
También para Pioneer AVH-P3200BT: Manual de instalación (8 páginas)
![Pioneer AVH-P3200BT Manual de instalación](/uploads/products/server2/6608904/6608904.jpg)
Installation
Note
• Check all connections and systems before final
installation.
• Do not use unauthorized parts as this may cause
malfunctions.
• Consult your dealer if installation requires drilling
of holes or other modifications to the vehicle.
• Do not install this unit where:
— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result
of a sudden stop.
• Do not install the display where it may (i) obstruct
the driver's vision, (ii) impair the performance of
any of the vehicle's operating systems or safety
features, including air bags, hazard lamp buttons
or (iii) impair the driver's ability to safely operate
the vehicle.
• The semiconductor laser will be damaged if it
overheats. Install this unit away from hot places
such as near the heater outlet.
• Optimum performance is obtained when the unit
is installed at an angle of less than 30°.
• When installing, to ensure proper heat dispersal
when using this unit, make sure you leave ample
space behind the rear panel and wrap any loose
cables so they are not blocking the vents.
Leave ample space
• To some types of vehicles, this unit cannot be
properly installed. In such case, use the optional
installation kit (ADT-VA133).
Installation using the screw
holes on the side of the unit
Factory radio mounting bracket
Dashboard
Use either truss
(5 mm × 8 mm) or
flush surface (5 mm
× 9 mm) screws,
depending on the
bracket screw holes.
In some types of vehicles, discrepancy may
occur between the unit and the dashboard. If this
happens, use the supplied frame to fill the gap.
Fastening the unit to the factory
radio-mounting bracket.
Position the unit so that its screw holes are
aligned with the screw holes of the bracket,
and tighten the screws at 3 or 4 locations on
each side.
If the pawl gets in the way,
bend it down.
Note
Dashboard or console
11