Pioneer AVIC-F980DAB Manual de instalación - Página 25

Navegue en línea o descargue pdf Manual de instalación para Receptor Pioneer AVIC-F980DAB. Pioneer AVIC-F980DAB 32 páginas. Navigation av system
También para Pioneer AVIC-F980DAB: Manual de inicio rápido (16 páginas), Instrucciones de actualización del firmware del sistema (5 páginas)

Installation

! The cords must not cover the area shown

in the figure below. This is necessary to

allow the amps and navigation mechanism

to dissipate heat.

Do not cover this area.

! The semiconductor laser will be damaged

if it overheats, so don't install this product

anywhere hot — for instance, near a heater

outlet.

Parts supplied

This product

Flush surface screw

(5 mm × 9 mm)

(6 pcs.)

Installation using the screw

holes on the side of this product

% Fastening this product to the factory

radio-mounting bracket.

Position this product so that its screw holes

are aligned with the screw holes of the brack-

Truss head screw

(5 mm × 8 mm)

(6 pcs.)

et, and tighten the screws at three locations

on each side.

Use either the truss head screws (5 mm ×

8 mm) or flush surface screws (5 mm ×

9 mm), depending on the shape of the brack-

et's screw holes.

If the pawl interferes with installation,

you may bend it down out of the way.

1 Factory radio-mounting bracket

2 Dashboard or console

3 Truss head screw or flush surface screw

Be sure to use the screws supplied with

this product.

Engb

Section