Pioneer VSX94TXH - Elite AV Receiver Manual de instrucciones - Página 3
Navegue en línea o descargue pdf Manual de instrucciones para Receptor Pioneer VSX94TXH - Elite AV Receiver. Pioneer VSX94TXH - Elite AV Receiver 8 páginas. Elite a/v receiver firmware update instructions for hdmi, dsp, event, and main microcomputers, dsp1 & dsp2 flash rom
También para Pioneer VSX94TXH - Elite AV Receiver: Especificaciones (2 páginas), Manual de instrucciones (19 páginas)
Imprimir página
HDMI microcomputer:
1. Follow the steps under "I. HDMI, DSP, EVENT, and MAIN microcomputers", "Preparations:" on page 2.
2. Enter Service Mode by holding the "ENTER" (21) and then the "MULTI- ZONE ON/OFF" (15) keys together for
about 3 seconds.
3. Within 4 seconds press the
4. Within 4 seconds press the "ENTER" (21) key and "HDMI DL [GO ON]" is displayed.
Open the UFU.exe program and select "Full" in "Mode Select" box. Click on the "File Selection" button.
5.
6. Select the latest HDMI u-com firmware file (Example: 07MID_hdmi_flash_1006.mot). Check Pioneer's ASC
website for the latest firmware files.
7. Select communication port/speed and format:
•
Select the COM Port. This must match the available COM port on your PC. Ex: COM 1
Note: If
"Target device is
for the correct type, cable connections, and COM port settings on your PC.
•
Base speed: 19,200.
•
Data Send speed: 57,600 or 19,200. Try 57,600 first as this will shorten the upgrade time.
•
Transmission format: "S"
8.
Click on the "START" button.
The UFU software will check the communication and baud rate between the PC and AV receiver and then
downloading should start in a few seconds.
9.
When finished "Update complete" is shown in the "Update Information" box. This can take up to 12 minutes.
Note: If you want to upgrade another unit with the same firmware. Just click "START" again. Click "EXIT' when
you want to change to different firmware or have finished with all the updates.
10.
Disconnect the receiver's AC for 10 seconds and then reconnect it. Exit the UFU.exe program.
11.
Check the version. See page 7.
(21) key to select "HDMI DL [START]".
connected" is not shown in the "Update Information" box, check the RS232c cable
3
Pioneer Electronics Service, Inc
SE Dept, QA Division
Rev date: 07/02/2008