Pioneer XV-DV430 Manual

Navegue en línea o descargue pdf Manual para Receptor Pioneer XV-DV430. Pioneer XV-DV430 2 páginas. Dvd/cd receiver
También para Pioneer XV-DV430: Manual de instalación (2 páginas)

Imprimir página

Setting Up your XV-DV430 DVD/CD Receiver

When connecting this system or changing connections, be sure to switch the power off with the STANDBY/ON button, and disconnect the power cord from the AC outlet.

Do not use these speakers with any other system or amplifier as this may result in damage or fire.

Check that you have all the accessories, then put

the batteries in the remote control.

Batteries and

remote control

Power cord

STANDBY/ON

FM/AM

L1/L2

DVD

TUNER

LINE

DISPLAY

OPEN CLOSE

DVD MENU

RETURN

TUNE+

ST–

ST+

ENTER

MUTE

TUNE–

SOUND

Video cord

MASTER

VOLUME

TV CONTROL

VOL

INPUT

OPEN

FM antenna

AM loop antenna

Satellite speakers: • Center (1)

• Front/Surround (x4)

• Subwoofer (1)

• Speaker cords (x6)

• Non-slip pads (x24)

Connect each speaker using the color-coded

speaker cords. Match them to the colored labels

above the speaker terminals.

FRONT

CENTER

SURROUND

SPEAKERS

SUB

WOOFER

For the best surround sound, setup your

speakers as above. The front left and right

speakers should be about 6–9 ft apart.

01.02

Connect the AM and FM antennas to the rear panel of the DVD/CD receiver.

Pull off the protective

shields of both AM antenna

wires.

Push open the tabs, then insert

one wire fully into each terminal.

Release the tabs to secure the AM

antenna wires.

Fix the AM loop antenna to the

attached stand.

To fix the stand to the antenna, bend in the

direction indicated by the arrow (fig. A) then

clip the loop onto the stand (fig. B).

Note: If you plan to mount the AM antenna

to a wall or other surface, secure the stand

with screws (fig. C) before clipping the loop

to the stand. Make sure the reception is clear.

Place the AM antenna on a flat

surface and point in the direction

giving the best reception.

Don't let it come into contact with metal

objects and avoid placing near computers,

television sets or other electrical appliances.

Surround right

Surround left

(Grey)

(Blue)

OUT

Listening position

AUDIO

LINE 1

Subwoofer (Purple)

Front right

Center (Green)

Front left

(Red)

Remove the supplied non-slip pads from the paper, and stick four

onto the base of each satellite speaker.

Actual speakers supplied may differ from those shown.

fig. A

fig. B

UNBAL 75Ω

LOOP ANTENNA

ANTENNA

Connect the FM wire antenna to the FM UNBAL 75Ω antenna terminal.

For best results, extend the FM antenna fully and fix to a wall or door

frame. Don't drape loosely or leave coiled up.

Note:

The signal earth (H) is designed to reduce noise that occurs when an

antenna is connected. It is not an electrical safety earth.

Connect each speaker as shown below.

Color-coded wire

(Connect to speaker)

Color-coded connector

(Connect to rear panel)

Twist and pull off the protective

shields on each wire.

Connect the wires to the

speaker. Match the colored

wire with the color-coded

label (above the tabs), then

insert the colored wire into

the red (+) tab and the other

wire with the black (–) tab.

Connect the other end to the

color-coded speaker jacks on

the rear of the DVD/CD

receiver (as shown at left).

Make sure to insert completely.

(White)

These speaker terminals can be hazardous when live. When you connect or

disconnect the speaker cables, to prevent the risk of electric shock, do not

touch uninsulated parts before disconnecting the power cord.

03.4.2, 9:44 AM

Using the remote control

The remote control can be used within a range of about 21 ft from the remote sensor on the front panel, and within a 30

degree angle.

Precautions:

• The remote control may not work if there is an obstacle between the remote control and the display unit, or if the remote

control is not directed towards the remote sensor of the display unit at the correct angle.

• The remote control may not work properly if strong light such as direct sunlight or fluorescent light is shining onto the

unit's remote sensor.

fig. C

• The remote control may not work properly when this unit is used near devices emitting infrared rays, or when remote

controls of other devices which use infrared rays are used. Also, the use of this remote control may cause other devices to

work improperly.

• When the operating range of the remote becomes too short, replace the batteries.

Remote control battery caution

Incorrect use of batteries may cause leakage or rupture.

Always be sure to follow these guidelines:

• Always insert batteries into the battery compartment correctly matching the

positive ª and negative · polarities, as shown by the display inside the compartment.

• Never mix new and used batteries.

• Batteries of the same size may have different voltages, depending on brand. Do not mix different brands of batteries.

• When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules

that apply in your country or area.

• In order to prevent battery leakage, remove the batteries when not using the remote control for an extended period (one

month or more). If leakage occurs, carefully wipe away any battery fluid inside the compartment, and replace the batteries

with new ones.

• Do not allow books or other objects to rest on top of the remote control, since the buttons may be depressed, causing

faster exhaustion of the batteries.

Additional notes on connecting antennas

• Keep antenna cables away from other cables and the display unit and main set.

• To assure optimum reception, pull the FM antenna so that it is fully extended and not coiled or hanging at the rear of the unit.

• If reception with the supplied antenna is poor, see the Additional Connections section in the main operating instructions

for details on connecting outdoor antennas.

Additional notes on speaker placement

Place speakers as shown in step 4 to achieve the optimum surround sound effect

• Install the main front left and right speakers at an equal distance from the TV.

• For optimum effect, install the rear speakers slightly above ear level.

• This system's speakers are magnetically shielded, so there's virtually no picture color distortion when they are placed near

a TV. In the rare event that there is some picture color interference, switch power to the TV off, and wait 15 to 30 minutes

before switching on again.

• Install the center speaker above or below the TV so that the sound of the center channel is localized at the TV screen.

• When installing the center speaker on top of the TV, be sure to secure it with tape or some other suitable means.

Otherwise, the speaker may fall from the TV due to external shocks such as earthquakes, endangering those nearby or

damaging the speaker.

• Do not connect the supplied speakers with any other amplifier. This may result in malfunction or fire.

Connect the DVD/CD receiver to your TV, then connect the

supplied power cord.

Connect one end to a video input on your TV.

Use the supplied video cord.

Connect the other end to the video output of the DVD/CD receiver.

This player is equipped with copy protection technology. Do not connect this

player to your TV via a VCR using AV cables, as the picture from this player will not

appear properly on your TV.

Connect the power cord to the AC inlet.

VIDEO IN

OUT

OPTICAL IN

AUDIO

FRONT

CENTER

SURROUND

SPEAKERS

LINE 2

ANTENNA

UNBAL 75Ω

AUDIO

LINE 1

AC IN

S-VIDEO

VIDEO

WOOFER

SUB

OUT

VIDEO

COMPONENT VIDEO OUT

AC IN

Congratulations! You're done setting up.

LOOP ANTENNA

VIDEO

OUT

VIDEO

To AC outlet

Printed in

<XRE3074-A>