Pioneer A-407R Manual de servicio - Página 27

Navegue en línea o descargue pdf Manual de servicio para Amplificador Pioneer A-407R. Pioneer A-407R 29 páginas. Stereo amplifier
También para Pioneer A-407R: Manual de instrucciones (12 páginas)

Imprimir página

REC SELECTOR switch /indicator(For TAPE 1/MD

terminals)

This switch is used to select the recording source component.

The signal from the selected component is output at the TAPE1/

MD jacks for recording. To select a recording source compo-

nent, press the REC SELECTOR switch so that the indicator of

the desired source component lights up. When this switch is set

to [TUNER] or [CD], the signal from the selected component can

be recorded regardless of the input selector switch and TAPE2

MONITOR button settings.

: To record from the equipment connected to the CD

terminals.

TUNER : To record from the equipment connected to the

TUNER terminals.

SOURCE : To record from the equipment selected by the IN-

PUT SELECTOR knob.

OFF

: In this position, nothing from the REC terminals of

TAPE 1/MD is output. Set to this position when not

recording; the cassette deck will be disconnected,

improving sound quality.

NOTE:

The function selected using the INPUT SELECTOR knob will be

recorded irrespective of the position of the REC SELECTOR

switch (TAPE 2 MONITOR terminals).

BALANCE control

Should normally be left in the center position. Adjust the balance

if the sound is louder from one of the speakers. If the right side is

louder, turn toward the L (left) position and if the left side is louder,

turn toward the R (right) position.

NOTE:

This control does not operate when the DIRECT button is in the

on position.

9 DIRECT button/indicator

Use this button when you do not wish to pass the output from

input terminal equipment through the various frequency adjust-

ing circuits (BASS, TREBLE, BALANCE, LOUDNESS).

On : The indicator lights. The signals input through the input

terminals are reproduced without passing through the

various frequency adjusting circuits. This results in flat,

pure sound which is a more faithful reproduction of the

input source.

Off : The indicator goes out. The signal passes through the

various frequency adjusting circuits.

LOUDNESS button/indicator

Use when listening at low volume level.

On : The indicator lights. Boosts low and high frequencies to

give added punch to playback even at low volume level.

Off : The indicator goes out. Should normally be left in this

position.

NOTE:

This button does not operate when the DIRECT button is in the

on position.

TREBLE tone control

Use to adjust the high-frequency tone. The center position is the

flat (normal) position. When turned to the right, the high-frequency

tone is emphasized; when turned to the left, the high-frequency

tone is de-emphasized.

NOTE:

This control does not operate when the DIRECT button is in the

on position.

BASS tone control

Use to adjust the low-frequency tone. The center position is the

flat (normal) position. When turned to the right, the low-frequency

tone is emphasized; when turned to the left, the low-frequency

tone is de-emphasized.

NOTE:

This control does not operate when the DIRECT button is in the

on position.

PHONES jack

When using headphones, insert the plug into this jack.

SPEAKERS B (ON/OFF) button/indicator

Use this button to listen to the speaker system connected to the

SPEAKERS B terminals.

On : The indicator lights. Sound is heard from the speaker sys-

tem.

Off : The indicator goes out. No sound is heard from the

speaker system. Set to this position when listening with

headphones.

SPEAKERS A (ON/OFF) button/indicator

Use this button to listen to the speaker system connected to the

SPEAKERS A terminals.

On : The indicator lights. Sound is heard from the speaker sys-

tem.

Off : The indicator goes out. No sound is heard from the

speaker system. Set to this position when listening with

headphones.

A-407R