Pioneer Elite SX-A9-J Manual de instrucciones - Página 17
Navegue en línea o descargue pdf Manual de instrucciones para Amplificador Pioneer Elite SX-A9-J. Pioneer Elite SX-A9-J 28 páginas. Operating instructions
También para Pioneer Elite SX-A9-J: Hoja de especificaciones (2 páginas), Manual de instrucciones (28 páginas)
Imprimir página
Using the tuner
Chapter 5:
Using the tuner
Listening to the radio
The following steps show you how to tune in to
FM and AM radio broadcasts.
1
Press TUNER then press BAND to select
the tuner band.
2
Tune to a station.
There are four ways to do this:
Automatic tuning – Press and hold TUNE
+/– for about a second. Searching
automatically stops at the next station.
Manual tuning – To change the frequency
one step at a time, press TUNE +/–.
High speed tuning – Press and hold
TUNE +/– continuously.
Direct access – Use the number buttons to
enter the frequency (For example, to tune
to 106.00 (FM), press 1, 0, 6, 0, 0).
If the TUNED or STEREO indicators don't light
when tuning to an FM station because the
signal is weak, press the MPX button to switch
the receiver into mono reception mode. This
should improve the sound quality and allow
you to enjoy the broadcast.
Saving station presets
This receiver can memorize up to 30 stations,
stored in three banks of 10 stations each.
1
Tune to a station you want to memorize
then press T.EDIT.
The display shows ST. MEMORY, then a
blinking memory class.
Note
1 If you make a mistake halfway through, press D.ACCESS twice to cancel the frequency and start over.
2 When saving an FM frequency, the MPX setting is also stored.
3 Station memories will be lost if the receiver is left disconnected from the AC power outlet for an extended period.
2
Press CLASS to select one of the three
classes then press ST +/– to select the station
preset you want.
3
Press ENTER to store the station.
Naming station presets
You can your station presets for easy recall.
1
Choose the preset you want to name.
See Listening to station presets below.
2
Press T.EDIT.
A cursor appears at the first character position.
3
Input the name you want then press
ENTER.
Names can be up to four characters long.
• Use the ST +/– buttons to select
characters, and ENTER to confirm. If no
character is input, a space is input.
1
Tip
• Once you have named a station preset, you
can press DISPLAY when listening to a
station to switch the display between the
name and the frequency.
Listening to station presets
You will need to have some presets stored to do
this. See Saving station presets above if you
haven't done this already.
2
1
Press TUNER to select the tuner.
3
05
17
En