Pioneer Elite SX-A9-J Manual de instrucciones - Página 10
Navegue en línea o descargue pdf Manual de instrucciones para Amplificador Pioneer Elite SX-A9-J. Pioneer Elite SX-A9-J 28 páginas. Operating instructions
También para Pioneer Elite SX-A9-J: Hoja de especificaciones (2 páginas), Manual de instrucciones (28 páginas)
Imprimir página
02
Connecting up
4
Place the AM antenna on a flat surface
and in a direction giving the best reception.
5
Connect the FM wire antenna in the same
way as the AM loop antenna.
For best results, extend the FM antenna fully
and fix to a wall or door frame. Don't drape
loosely or leave coiled up.
Using external antennas
To improve FM reception
Use a 75 Ω coaxial cable to connect an external
FM antenna.
To improve AM reception
Connect a 5 m to 6 m (15 ft. to 18 ft.) length of
vinyl-coated wire to the AM antenna terminal
without disconnecting the supplied AM loop
antenna.
FM UNBAL
75
For the best possible reception, suspend
horizontally outdoors.
10
En
Downloaded from
www.Manualslib.com
One-touch
PAL connector
FM UNBAL
AM LOOP
75
75 Ω coaxial cable
Outdoor
antenna
5 m to 6 m
(15 ft. to 18 ft.)
Indoor antenna
(vinyl-coated wire)
ANTENNA
AM LOOP
manuals search engine
Connecting the speakers
Make sure you connect the speaker on the
right to the right terminal and the speaker on
the left to the left terminal. Also make sure the
positive and negative (+/–) terminals on the
receiver match those on the speakers. You can
use speakers with a nominal impedance
between 4 Ω–16 Ω.
Be sure to complete all connections before
connecting this unit to the AC power source.
ANTENNA
CONTROL
OUT
OUT
SIGNAL
GND
L
R
MM/MC
PHONO
•
Connect the speakers to the speaker
terminals as shown above.
Connections for the left speaker are shown.
Connect the right speaker in the same way. You
can use either bare wire connections or
banana plugs to do this (see below).
Bare wire connections
Make sure that the speaker cable you're going
to use is properly prepared with about 3/8 inch
of insulator stripped from each wire, and the
exposed wire strands twisted together (fig. A).
Left speaker
AC IN
L
SPEAKER