Pioneer GM-D8601 Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Amplificador Pioneer GM-D8601. Pioneer GM-D8601 15 páginas. Class d mono amplifier
También para Pioneer GM-D8601: Manual del usuario (45 páginas), Manual del usuario (49 páginas)

Imprimir página

Section

Connecting the units

Route battery wire from engine com-

partment to the vehicle interior.

! When drilling a cable pass-hole into the ve-

hicle body and routing a battery wire thor-

ough it, take care not to short-circuit the

wire damaging it by the cut edges or burrs

of the hole.

After completing all other amplifier connec-

tions, finally connect the battery wire terminal

of the amplifier to the positive (+) battery

terminal.

1 Positive (+) terminal

2 Battery wire (sold separately)

The maximum length of the wire between

the fuse and the positive + terminal of the

battery is 30 cm (12 in.).

3 Fuse 100 A (GM-D8601) / 150 A (GM-D9601)

(sold separately)

Each amplifier must be separately fused at

100 A (GM-D8601) / 150 A (GM-D9601).

Use wire cutters or a utility knife to

strip the end of the battery wire, ground

wire and system remote control wire to ex-

pose about 10 mm (3/8 in.) of the end of

each of the wires, and then twist the ex-

posed ends of the wires.

Connect the wires to the terminal.

Fix the wires securely with the terminal

screws.

Twist

10 mm (3/8 in.)

1 Battery wire

2 Power terminal

3 Ground wire

4 GND terminal

5 System remote control wire

6 System remote control terminal

7 Terminal screws

Connecting the speaker output

terminals

Use wire cutters or a utility knife to

strip the end of the speaker wires to ex-

pose about 10 mm (3/8 in.) of wire and

then twist the wire.

Connect the speaker wires to the

speaker output terminals.

Fix the wires securely with the terminal

screws.

1 Terminal screws

2 Speaker wires

3 Speaker output terminals

Twist

10 mm (3/8 in.)