Pioneer SA-V210 Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Amplificador Pioneer SA-V210. Pioneer SA-V210 8 páginas. Stereo mixing amplifier
También para Pioneer SA-V210: Manual de servicio (23 páginas)

Imprimir página

CONNECTIONS

Connection of Speaker Cord

Strip off the vinyl coating and put the wire ends together.

Speaker (right)

Speaker (left)

impedance of Speaker System

Speaker systems with a nomina! impedance of 4 to 16 2 can be used

when systems A or B are used separately. Use nominal impedance of

8 to 32. when playing both systems simultaneously.

PANEL FACILITIES

Connection of Input.and Output Cords

* Connect white piug to "L" side and red plug to "R" side. Make

sure to insert them securely.

@ &

White plug

Red plug

Insert

the

plug

the

connecting

cords

securely.

Incomplete plugging may result in noise or insufficient sound.

LINE VOLTAGE SELECTOR SWITCH

Mains voltages in Saudi Arabia are 127 V and 220 V only. Never use

this model with 110 V setting in Saudi Arabia.

Before your model is shipped from the factory, the switch is set to the

power requirements of the destination; nevertheless, you should check

that they are set properly before plugging the power cord into the AC

outlet.

1. Check the power cord disconnected.

2. Use a medium-size screwdriver.

3. Insert the screwdriver into the groove on the voltage selector, and

adjust so that the tip of the arrow points to the voltage value of your

area.

VOLTAGE SELECTOR

s20-127¥

240V

220v

Medium-size screwdriver

See page 2 for location of Panel Facifities

REAR PANEL

\. AUDIO INPUT jacks

@ LASERDISC

Connect to the AUDIO jacks of a LD player.

m@YvCR

Connect to the AUDIO

OUT jacks of a VCR.

@ CABLE

For input of monophonic audio signals from cable receivers

etc, When both terminals are connected select 1 or 2 using

the sending device.

Mt TAPE/AUX

Can

connected

to the

PLAY

(OUTPUT)

jacks of a

cassette

deck

or to the OUTPUT

jacks of other

audio

components.

'2 VCR SOURCE

SELECTOR SENSITIVITY switch

Switch it for proper operation of the AUTO SOURCE SELECTOR

function of the SA-V210.

For the AUTO

SOURCE

SELECTOR

function, see page 6.

M>: Normal position

(When no LASERDOISC signal is input.}

i "TAPE/AUX"

or "CABLE"

terminal

is automatically

selected even though VCR is being played , set to this

position "L" to select VCR.

(When no LASERDISC signal is input.)

If "TAPE/AUX" or "CABLE" is not selected even though

VCR

finishes its playback,

set to this position

"H" to

select "TAPE/AUX"

or "CABLE."

3. VCR VGLUME control

Controls the volume of the VCR input terminals sound:

This control is normally centered

but should be adjusted in

accordance with the volume of the LASERDISC.

<4: VCR MODE switch

This

switch

is used

select

the

VCR

audio

modes

{MONO/STEREO}.

Connect a VCR with monophonic audio output either to "L" or

'R" AUDIO

INPUT jack and set this switch to "MONO."

i5) CABLE VOLUME contro!

Controls the volume of the CABLE

input terminals sound.

This contro! is normally centered but should be adjusted in

accordance with the volume of the LASERDISC.

SOURCE

SELECTOR

SENSITIVITY

switch

Switch

it for

proper

operation

the

AUTO

SOURCE

SELECTOR function of the SA-V210.