Pioneer SP-X707 Manual de instrucciones - Página 3

Navegue en línea o descargue pdf Manual de instrucciones para Amplificador Pioneer SP-X707. Pioneer SP-X707 23 páginas. Surround amplifier

Imprimir página

@CONTROL input jack (IN)

@CONTROL

output jack (OUT)

This jack can be used to send the control signals to still

an-

other" i] '' unit just as the above-described IN jack is

used to relay signals from the television to the SP-X707.

By connecting a line from this OUT jack to the IN terminal

of another component of a system, the whole

system can

be controlled by remote control. Components having an

terminal but not signal receiver can also be remote

controlled

through the SP-X707

by connecting them to this jack as

_the last component

in the system.

amplifiers.

channel speaker.

@SWITCHED AC OUTLET (MAX. 200W)

Ensure that the combined power consumption of the

components connected to these outlets does not exceed

200 watts.

this outlet.

Power consumption

of AC outlets

Under no circumstances should an electrical appliance (such

as a toaster or hair drier) with a power consumption exceed-

ing the maximum rating marked on the panel be connected

to these outlets since malfunctioning or breakdowns may

result.

@®INPUT BALANCE (L, R) control

@INPUT jacks

@OUTPUT FIX jacks (fixed)

REAR PANEL FACILITIES

@OUTPUT VAR jacks (variable)

These jacks serve

as the output jacks whenever

using the

SP-X707

in combination

with a non

Audio-Video

master

amplifier. Connect them to the tape play (PLAY) terminals of

the amplifier using the accessory pin-plug connection cord.

TAPE jacks

Use these jacks to connect a tape deck to your SP-X707.

@) LINE OUT jacks (SURROUND)

The same signals output to the surround speakers are out-

put as line output signats through these jacks. They can be

used to enhance the surround sound-effect connecting them

to the AUX input terminals of a high-powered stereo ampli-

fier and adding surround speakers.

BEFORE CONNECTING

@ SPEAKERS (SURROUND) terminals

Connect these to the speaker systems installed at the rear.

"R' is for the system installed on the right and ''L'' for the

system installed on the left.

Speaker impedance

Use speaker systems with an impedance ranging from 6 to

16 ohms for connection to the SPEAKERS-terminals.

@ Power cord

Connect this to a wall AC outlet or to the electrical outlet of an

amplifier.

Or, if you have combined the unit with a Pioneer Audio-Video

master

amplifier,

connect

the

"AC

OUTLETS

SWITCHED".

" Connecting speaker wires

1. Remove the vinyl covering and twist the wire core.

10mm

2. Press the lever down, and insert the wire core into the

hole. Be sure to connect the plus

wire to the

3. Raise the lever.

NOTE:

that it is connected securely to its terminal.

* Do not allow the wire core or protrude from its terminal

and contact other wires or terminals. If the cores of two

wires touch each other, damage

to components

could

result,

Connecting the audio input/output cords

* Connect the white plug to the left (L) terminal and the

red plug to the right (R) termina}. Be sure that the plugs

are pushed in as far as they will go.

7 .

White

Red