Pioneer SX-201 Manual de instrucciones - Página 15

Navegue en línea o descargue pdf Manual de instrucciones para Amplificador Pioneer SX-201. Pioneer SX-201 17 páginas. Stereo control amplifier
También para Pioneer SX-201: Manual de instrucciones (28 páginas)

Imprimir página

1. Rear Panel Facilities

TROUBLESHOOTING

Symptom

Cause

Power does not come.on even

when POWER switch is pressed.

* Power cord is disconnected.

Connect cord securely.

No sound is produced, even

ed,

when Function switch is select-

¢ VOLUME control

is set to O (MIN).

*° Speaker connecting wires are disconnected

from speaker terminals

® One or both of the input cords are disconnect-

ed.

*° TAPE 2 MONITOR

button is in the ON posi-

tion.

Turn the VOLUME

control toward the right.

Connect wires to terminals securely.

Connect input cords securely.

Press the button to OFF position,

Sound is produced from one

speaker only.

® BALANCE control is set too far to one side or |

the other.

*° One of the speaker connecting wires or input

cords is disconnected.

Set BALANCE

control to center position.

Connect wires and cords securely.

Noise is produced during recep-

tion of AM broadcasts when the

power switch of other compo-

nents is turned ON or OFF.

* AM loop antenna picks up electrical noise

created by switch contacts.

Place AM loop antenna as far away as possible

from this and other components.

High noise level.

quency.

¢ Antenna has not been connected or has

become disconnected.

FM reception

° Accessory FM antenna remains bundied up.

¢ Weak broadcasting station signals.

Noise picked up from other equipment (or, in

particular, from passing automobiles).

ing station entering antenna directly are mixed

with signals which have been reflected by

mountains or high buildings on their way to an-

tenna. this results in distorted sound and

noise.

AM reception

® AM antenna not pointing in right direction.

° Weak broadcasting station signals.

¢ Noise being picked up from other equipment

(especially electrical appliances using motor or

fluorescent lights).

Tune the station correctly.

Connect the antenna securely.

Stretch the antenna taut and locate in direc-

tion yielding optimum reception.

Replace accessory FM antenna with outdoor

FM antenna.

Try altering direction and mounting position of

antenna. lf an outdoor antenna has been erect~

ed, place it as far as possible from passing

traffic and replace connecting cable with 75 Q

coaxial cable.

Change AM antenna's direction and find a posi-

tion where reception is improved.

Erect outdoor AM antenna or connect ground

wire,

Stop using appliances generating noise or re

move them from vicinity of stereo equipment.

No auto stop. (FM reception)

@ Input signals are not strong enough.

If an accessory FM antenna is used, change

over to an outdoor antenna.

Perform manual tuning.

<SX-311R,

SX-251R only >

Remote control does not work.

* Batteries are dead or no batteries in remote

control unit.

® Poor angle or too great a distance from the re-

mote sensor window

¢ There is an obstacle between you and the re-

mote sensor window.

* For CD player and cassette decks, the remote

control cord is not connected.

* A fluorescent light is shining on the remote

sensor window.

Insert new batteries.

Use within 7 meters (23 feet) and within a 30

degree angle of the remote sensor window.

Change your position or move the obstacle.

Correctly connect remote control cord.

Turn off the light.