Pioneer VSA-1000 Manual de instrucciones - Página 5
Navegue en línea o descargue pdf Manual de instrucciones para Amplificador Pioneer VSA-1000. Pioneer VSA-1000 35 páginas. Av digital surround amplifier
También para Pioneer VSA-1000: Manual de instrucciones (35 páginas)
Imprimir página
SURROUND
EFFECT
SURROUND SPEAKER INSTALLATION EXAMPLE
To get the best effect out of the surround system, place the speakers
as shown below.
Atypical surround speaker arrangement
CENTER SPEAKER
FRONT
When DOLBY PRO LOGIC SURROUND
is used without a center
speaker, set the CENTER MODE switch to the PHANTOM
position.
With DOLBY PRO LOGIC SURROUND, monaural source sound will be
heard only from the center channel at settings other than the PHANTOM
position.
NOTE:
* To avoid interference with the picture on a nearby TV set, use
magnetically shielded speaker systems. This is particularly important
for the center speaker since it is usually located closest to the TV.
* Position the left and right channel speakers at equal distances from
the TV set.
° Position the center speaker above, below, or behind the TV set. Sound
may not appear to coincide with the picture if you position it next to
the TV set.
© Surround speakers are best positioned to set slightly above ear level.
DOLBY
SURROUND
LEVEL
ADJUSTMENT
PROCEDURE
For
correct
SURROUND
reproduction,
be sure
to
perform
this
adjustment.
1. Use SURROUND
MODE switch to select DOLBY PRO LOGIC
SURROUND.
. Use SPEAKER switches to turn on front, rear and center speakers.
. Adjust MASTER VOLUME to a suitable listening level.
. . Select a monaural source (such as AM radio) or Dialogue portions
of movies.
. Press BALANCE L and R switches together.
. Press CENTER LEVEL
+ and - switches together.
. Press REAR LEVEL
+ and - switches together.
. Select the CENTER MODE switch to the OFF position.
. Adjust rear panel INPUT BALANCE knob to the position that gives
minimum volume from the front and rear speakers.
10. Select CENTER MODE (NORMAL, WIDE, PHANTOM} setting.
11. Turn on TEST TONE switch.
12. Adjust so that volume
is the same from each speakers. Use
BALANCE L and R switches, REAR LEVEL + and — switches, and
CENTER LEVEL switches.
13. Turn off TEST TONE switch when finished.
14,Use AUDIO INPUT SELECTOR or VIDEO INPUT SELECTOR to
select your desired source.
15. Adjust the desired sound level by the MASTER VOLUME.
NOTE:
© Set in the range of 12 to 15 by remote control operation from the
listening/viewing position.
© The TEST TONE turns off if you operate the INPUT SELECTOR.
PWN
OOnNOon
5
<ARB1177>