Pioneer VSA-E03 Manual de instrucciones - Página 19

Navegue en línea o descargue pdf Manual de instrucciones para Amplificador Pioneer VSA-E03. Pioneer VSA-E03 48 páginas. Audio/video multichannel amplifier

Imprimir página
Setting the volume level of each channel (Adjusting the speaker volume balance)
• Sound from the SUB WOOFER seems quiet.
memo
• The speaker volume can be adjusted without outputting the test tone by pressing CHANNEL LEVEL or
CHANNEL SELECT .
• Initial setting is 0 dB.
AMP
TV
FQ
+
ENTER
–
FQ
VOL
VOL
CHANNEL
MULTI CONTROL
DVD/LD
TV/SAT
CD
VCR 1
TV CONTROL
TUNER
MD/TAPE
VCR 2
AMP
1
DSP MODE
MIDNIGHT
1
2
3
4
CH.SELECT
TEST TONE
ATT SIG.SELECT
5
6
7
8
CH.LEVEL
EFFECT
4
9
0
+10
MEMU
CLASS
TV/VCR
FUNCTION
DIRECT
FL DIMMER
COMMANDER
MODE CHECK
SET UP
Î
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
1
Press
.
2
Press VOL + or – to adjust the volume to an appropriate
level.
3
Press TEST TONE to output the test tone.
2
The test tone is output in the following order.
FL
SW
3,5
memo
• Depending on the "SPEAKER setting mode" chosen, some
channels may not output test tone (refer to page 15).
• Test tone is only output in Dolby Surround mode.
4
Adjust speaker levels so that you hear the test tone at
the same volume from each speaker when seated in the
main listening position.
The channel level ranges +10dB~ –10dB.
• Levels can be set for each surround mode.
memo
• When both the DSP mode and Dolby Surroud mode are turned
on, priority is given to the Dolby Surround mode.
5
Press TEST TONE to turn off the test tone.
CT
FR
SL
SR
Preparations
19
En