Pioneer CLD-1720K Manual de instrucciones - Página 39

Navegue en línea o descargue pdf Manual de instrucciones para Reproductor de CD Pioneer CLD-1720K. Pioneer CLD-1720K 45 páginas. Cd cdv ld player

Imprimir página

TROUBLESHOOTING

incorrect operations often cause troubles and malfunctions. !f you think that there is something wrong with this component,

check the points below. Sometimes the trouble may lie in another component. Inspect the other components and electrica

appliances being used.

if the trouble cannot be rectified even afier exercising the checks

listed below, ask your nearest

PIONEER authorized service center or your dealer to carry out repair work.

SYMPTOM

CAUSE

1. Disc table is not ejected when &

is pressed.

RaEee

Toate

Power cord is not properly plugged into

socket.

Power switch is not turned on.

2. Disc table cornes out.

Disc is dirty.

The disc is not properly set on the di:

Moisture has condensed on parts in the player.

Disc is warped.

3. Remote control does not work.

The CONTROL

IN terminal on the rear p:

connected to Pioneer projection monitor or AV

amplifier.

Batteries are weak.

There is an obstacle between the player and the

remote control unit.

Remote contro! unit is not in a good location for

transmission.

4. Operation of the remote control

unit causes the TV to operate

improperly.

operate improperly in response to the remote control

unit of the player.

Some TV sets have remote control functions that |

of cover the remote sensor of the TV

during disc playback.

REMEDY

1 power

ord.

switch.

properly.

candiet

player stand for 1 to i

lit is dry.

viate the warp. (Refer to |

, remedy column.)

te contro! unit at the

on monitor or AV amplifier.

batteries.

tacle or shift the remote

ote control unit in front

' a n d

the player further

apart,

Abnormal functioning of this unit may be caused by lightning,

static electricity, or other external interference.

To restore

normal operation, turn the power off and then on again, or

unplug the AC power cord and then plug it ia again.