Ariston Margherita 2000 Manual de instrucciones de instalación y funcionamiento - Página 10
Navegue en línea o descargue pdf Manual de instrucciones de instalación y funcionamiento para Lavadora Ariston Margherita 2000. Ariston Margherita 2000 17 páginas. Front-loading washing machine
También para Ariston Margherita 2000: Manual de instrucciones de instalación y uso (45 páginas)
Imprimir página
M
ARGHERITA
2000
The washing machine
does not drain or
spin.
Does
the
selected
programme incorporates
water draining? Some
programmes stop at the end of
the wash cycles and draining
will have to be selected
manually.
Is the Rinse-Hold"
function -where provided -
enabled? This function
requires manual selection for
draining.
Is the drain hose kinked?
The tract of the drain hose
must be as straight as possible.
Make sure the drain hose is not
squashed or kinked.
Always get
assistance from
authorised
technicians and
always insist on
original spare
parts.
Technical characteristics
Model
AB 65 X
width 59,5 cm
Dimensions
height 85 cm
depth 53,5 cm
from 1 to 5,5 kg
Capacity
Electrical
voltage 230/240 Volt 50-60 Hz
maximum absorbed power 1850 W
connections
maximum pressure 1 MPa (10 bar)
Water
connections
minimum pressure 0,05 MPa (0,5 bar)
drum capacity 46 litre
Spinning speed
up to 600 rpm
carried out with 5,0 kg load
Control programs
in compliance
with IEC
regulation 456
This appliance conforms with the following E.E.C. directives:
- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent modifications
- 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications
9
Margherita 2000 - Instructions for installation and use
Is the washing machines
drain duct clogged? Is there
an extension of the drain
hose? If so, is it positioned
incorrectly, blocking the water
flow?
Excessive vibration
during the spin cycle.
Have all transit screws been
removed durind instal-
lation? See the following
page
on
installation
procedures.
Has the washing machine
been levelled correctly? The
levelling of the appliance
should
be
checked
periodically. Adjust the feet
and check them with a level.
Is there space between the
machine and adjacent units?
If it is not a built-in model, the
washing machine will oscillate
a bit during the spin cycle. A
few cm of space should
therefore be left around it.
The washing machine
leaks.
Is the metal ring of the inlet
hose properly attached? Turn
off the water supply, unplug
the appliance and try
tightening its attachment
without forcing it.
Is the detergent dispenser
obstructed? Remove and
wash it under tap water.
Is the drain hose well
attached? Turn off the water
supply, unplug the appliance
and try tightening its
attachment.
Too much foam.
Is the detergent appropriate
for machine washing? Check
whether the definition on its
label reads for machine wash
or hand and machine wash,
or any other similar wording.
Is the correct amount being
used? An excessive amount of
detergent, besides producing
too much foam, does not
guarantee a more effective
wash, and causes scaling in the
internal parts of the appliance.
If, despite all checks, the
washing machine fails to
function and the problem
persists, call your nearest
authorised Customer Service
Centre, providing the following
information:
- the nature of malfunction
- the model type no. (Mod. ....)
- the serial number (S/N ....)
This information can be found on
the data plate situated at the back
of the washing machine.