Pioneer DV-515 Manual de servicio - Página 9

Navegue en línea o descargue pdf Manual de servicio para Reproductor de DVD Pioneer DV-515. Pioneer DV-515 26 páginas.
También para Pioneer DV-515: Manual de servicio (48 páginas)

Imprimir página

Special Mention Item

(1) Indications for the spindle status are as follows:

A/B : Spindle accelerator and brake

: FG servo

SRV : Rough, velocity/phase servo

O_S : Offset addition, rough, velocity/phase servo

(2) The movement of loading in/out starts from the tray open status.

After that, this function is executed unless a play and close

operation are done.

(3) There are three methods for entering a search address:

1 Absolute address designation

= Searching for the address entered

(indication for the most significant digit : > )

2 Additional input

= Searching for the address with the current ID number plus

an entered number

(indication for the most significant digit : + )

3 Subtractive input

= Searching for the address with the current ID number

minus an entered number

(indication for the most significant digit : – )

The above modes can be changed by pressing [+10] key.

Note : A number for addition or subtraction must be entered in

hexadecimal.

(4) If disc-type designation is forcibly executed during a mode other

than Checker mode, the system controller will abandon disc-

type designation after setting the mechanism controller.

Therefore, after startup of the player, disc sensing will be

performed again for safety.

If disc-type designation is forcibly executed during Checker

mode, as disc-type designation is not abandoned, playback will

be immediately started.

(5) A background color change in order of blue = green = light

blue = red = purple = yellow = gray = black = with the [2/

R] key.

It changes in order of gray = yellow = purple = red = light

blue = green = blue = black = in the case of the [1/L] key.

(6) 5.1CH forced output becomes 5.1CH mode, the speaker setting

will forcibly set to 3/2 + SW.

(7) Speaker setting change mode becomes 5.1CH mode, and it

changes in order of 3/2+SW = 3/2 = 2/2+SW = 2/2 =

3/0+SW = 3/0 = 2/0.

It is the same as the test mode and the checker mode.

2.4 THE EXPLANATION OF EACH

FUNCTION

2.4.1 FUNCTION

The function that can be operated in the test mode is as the following.

Use a LD test mode remote control unit in the test mode.

(1) Door Open/Close

1. Press [REPEAT A] (48) key of the remote control unit.

2. Press [OPEN/CLOSE] key of the player from the stop condition.

(2) Stop

1. Press [REPEAT B] (44) key of the remote control unit.

2. Press [STOP] key of the remote control unit or the player from

the stop condition.

(3) Play 1 (Demultiplex exist which it tries to output

the playback screen)

1. Press [PLAY] (17) key of the remote control unit.

• DVD rise up at the tracking close. Playback screen may not

appear because the NAVI information isn't read in the test mode.

(4) Play 2 (Demultiplex is absent which performing

trace only)

1. Press [TV/LDP] (0F) key of the remote control unit.

• Perform only tracing with DVD, and there are no video and

audio output.

2. Increase the address at the FTS coefficient indication mode.

(5) Pause

1. It becomes pause condition by pressing [CX] (0E) key of the

remote control unit in the play.

• ON/OFF changes alternately with DVD.

2. Pause ON/OFF changes alternately by pressing [PAUSE] (18)

key in the play.

• Only Play 2 is effective with DVD.

3. Decrease the address at the FTS coefficient indication mode.

(6) Tracking Open

1. Press [STEP FWD] (54) key of the remote control unit in the play

condition.

(7) Tracking Close

1. Press [STEP REV] (50) key of the remote control unit in the play

condition.

(8) Slider In

1. Press [SCAN REV] (11) key of the remote control unit in the

tracking off condition.

2. Turn the shuttle of the remote control unit in the REV direction

(2C to 2F) in the tracking off condition. (DVD only)

DV-515