Pioneer SDV-P7 - DVD Player - in-dash Manual de instalación

Navegue en línea o descargue pdf Manual de instalación para Reproductor de DVD Pioneer SDV-P7 - DVD Player - in-dash. Pioneer SDV-P7 - DVD Player - in-dash 8 páginas. Other manual

Imprimir página

1. Connecting the Units

SDV-P7

This product conforms to CEMA cord colors.

Le code de couleur des câbles utilisé pour ce produit est

conforme à CEMA.

Printed in Japan

Imprimé au Japon

<CRD3465-A> UC

Connecting the Units

Note:

• This unit is for vehicles with a 12-volt battery and

• To prevent incorrect connection, the input side of

negative grounding. Before installing it in a recre-

the IP-BUS connector is blue, and the output side

ational vehicle, truck, or bus, check the battery

is black. Connect the connectors of the same

voltage.

colors correctly.

• To avoid shorts in the electrical system, be sure to

• If this unit is installed in a vehicle that does not

disconnect the ≠ battery cable before beginning

have an ACC (accessory) position on the ignition

installation.

switch, the red lead of the unit should be connected

to a terminal coupled with ignition switch ON/OFF

• Refer to the owner's manual for details on

operations. If this is not done, the vehicle battery

connecting the power amp and other units, then

make connections correctly.

may be drained when you are away from the vehi-

cle for several hours. (Fig.1)

• Secure the wiring with cable clamps or adhesive

tape. To protect the wiring, wrap adhesive tape

around them where they lie against metal parts.

• Route and secure all wiring so it cannot touch any

moving parts, such as the gear shift, handbrake and

seat rails. Do not route wiring in places that get

hot, such as near the heater outlet. If the insulation

of the wiring melts or gets torn, there is a danger of

the wiring short-circuiting to the vehicle body.

• Don't pass the yellow lead through a hole into the

ACC position

No ACC position

engine compartment to connect to the battery. This

will damage the lead insulation and cause a very

dangerous short.

• Do not shorten any leads. If you do, the protection

circuit may fail to work when it should.

• Never feed power to other equipment by cutting

• Cords for this product and those for other products

the insulation of the power supply lead of the unit

may be different colors even if they have the same

and tapping into the lead. The current capacity of

function. When connecting this product to another

the lead will be exceeded, causing overheating.

product, refer to the supplied Installation manuals

of both products and connect cords that have the

• When replacing fuse, be sure to use only fuse of

the rating prescribed on the fuse holder.

same function.

When Connecting the Multi-Channel AV Master Unit

Multi-Channel AV

Master Unit (e.g. AVM-P9000R)

(sold separately)

Green

Yellow

Blue

Fig. 1

Blue

Optical cable (supplied with the

Multi-Channel AV Master Unit)

IP-BUS cable

(supplied with the TV tuner)

FM MODULATOR

IP-BUS MAIN UNIT

IP-BUS AV MASTER

RCA cable

(sold separately)

Red

20 pin cable

(supplied with the TV tuner)

IP-BUS

STAND ALONE

Black

RCA cable (supplied)

Yellow

6 m

IP-BUS cable

Blue

(supplied with the Multi-

Channel AV Master Unit)

V.SEL cable

(supplied with the display)

Speaker Unit

(supplied with the

display)

Black

Blue

Hide-away TV Tuner

(e.g. GEX-P7000TV)

(sold separately)

AV system Display

(e.g. AVX-P7000CD)

(sold separately)

IP-BUS cable

(supplied with the display)

Green

Gray

AV cable (supplied with the

Gray

Multi-Channel AV Master Unit)

Yellow (front video output)

This product

15 cm

Blue

Not used.

40 cm

Blue

Multi-CD player

(sold separately)

Blue

Black

Green

Gray

20 pin cable

(supplied with the display)

Fig. 2