Pioneer S-7EX XTW/E Manual de instrucciones - Página 2
Navegue en línea o descargue pdf Manual de instrucciones para Sistema de altavoces Pioneer S-7EX XTW/E. Pioneer S-7EX XTW/E 24 páginas. Ex series
También para Pioneer S-7EX XTW/E: Catálogo (20 páginas), Folleto y especificaciones (16 páginas), Manual de servicio (10 páginas)
Imprimir página
Thank you for buying this Pioneer product. Please read
through these operating instructions so you will know how to
operate your model properly. After you have finished reading
the instructions, put them away in a safe place for future
reference.
What's in the box
• Speaker spikes
(with attached nuts) x4
• Fastening screws
(for grille) x4
• Finishing screws
(for grille) x4
Features of this speaker system
• Construction follows leading-edge TAD technology
• Beryllium dual-concentric tweeter
• Aramid/carbon fiber reinforced composite 18 cm woofer
• Perfect time alignment design
Before you start
• The nominal impedance of this speaker system is 6 Ω.
Connect the speaker system to an amplifier with a load
impedance ranging from 4 Ω to 16 Ω (a model with "4 –
16 Ω" displayed on the speaker output terminals).
• Do not touch the speaker cones as they are easily
damaged.
In order to prevent damage to the speaker system resulting
from input overload, please observe the following precau-
tions:
• Do not supply power to the speaker system in excess of
the maximum permissible input.
• When connecting or disconnecting anything in your AV
system, make sure the amplifier is switched off.
• When using a graphic equalizer to emphasize loud
sounds in the high-frequency range, do not use exces-
sive amplifier volume.
• Do not try to force a low-powered amplifier to produce
loud volumes of sound (the amplifier's harmonic
distortion will be increased, and you may damage the
speaker).
Caution: installation
• Do not place the speaker on an unstable surface. It
could present a hazard if it falls, as well as damaging the
equipment. If placing the speaker on a thick carpet, we
2
En
• Spike bases x4
• Caps x10
• Speaker base x1
• Grille x1
• Operating instructions
recommend using the supplied speaker spikes for
stability.
• Switch off and unplug your AV equipment and consult
the instructions when connecting up components. Make
sure you use the correct connecting cables.
• Do not put a TV or other AV equipment on top of this
speaker. It could present a hazard if it falls, as well as
damaging the equipment.
• Do not install your speakers overhead on the ceiling or
wall. If improperly attached, the speaker grille can fall
and cause damage or personal injury.
• Do not attach these speakers to the wall or ceiling. They
may fall off and cause injury.
Caution: in use
• Do not use the speaker to output distorted sound for
long periods of times. This can result in a fire hazard.
• Do not sit or stand on the speaker, or let children play on
the speaker.
• Do not put large or heavy objects on top of the speaker.
WARNING: Handling the cord on this product or
cords associated with accessories sold with the
product will expose you to chemicals listed on
proposition 65 known to the State of California and
other governmental entities to cause cancer and
birth defect or other reproductive harm.
Wash hands after handling
Installing your speaker
Please observe the following points when installing speakers:
• This speaker is a bookshelf-type speaker which will give
best performance when placed on a solid, level surface
off the floor. Placing the speaker directly on the floor will
result in boomy, undefined sound. Ideally, the tweeter
should be at about ear level when seated in your
listening position. We recommend using the CP-7EX
speaker stand for optimal sound and stability.
If you choose to use the CP-7EX speaker stand, make sure
you secure it with the screws provided.
• Sounds played through speaker systems are easily
affected in subtle ways by the conditions in the listening
space.
• For good sound, the speaker should be about 20 cm
away from the back wall and at least 50 cm away from
the side wall. If the room has a lot of reverberation, we
recommend hanging heavy fabric on the walls, and/or
putting a carpet on the floor to damp the sound. For best
results, cover walls completely.
20 cm
D36-P4_A_En
50 cm