Pioneer S-V7000 Manual de instrucciones
Navegue en línea o descargue pdf Manual de instrucciones para Sistema de altavoces Pioneer S-V7000. Pioneer S-V7000 4 páginas.
SPEAKER SYSTEM
-VV 7000
BEFORE USE
Thank
you
very
much
for purchasing
this PIONEER
product.
Carefully read this Operating
Guide
to properly use
your speaker system. After reading, keep the Operat-
ing Guide for reference during operation.
Rated impedance of this speaker system is 8 ohms.
Connect the speaker system to a stereo amplifier with
load impedance
of 4 to 16 ohms
(indicated 4 to 16
ohms for the speaker output terminals).
Follow these instructions to prevent damage
to the
speaker system by excessive input:
e
Do not input beyond the allowable limits.
*
Turn off the amplifier power before connecting or
disconnecting the cords.
*
Do not turn up the volume when increasing treble
with the graphic equalizer.
OPERATING GUIDE
@Y PIONEER
The Art of Entertainment
CONNECTING TO AMPLIFIER
z
Turn off the amplifier power switch.
(POWER OFF)
Connect the speaker cords to the input terminals of
the speaker system. The speaker system is equipped
with two types of input terminals, screw-type input
terminal
(banana plug available) and phone-jack ter-
minal.
NOTE:
%
All input terminals are connected in parailel.
For input use one of these terminals.
tT
he speaker system
is connected to the amplifier using
the speaker cords, The red input terminal is for the plus
¢
+) cord wire and the black one is for the minus
(-)
cord wire.
Remove cable insulation
to expose the wires and
twist together.
\
After cannecting the cords to the terminals, confirm
that the cords are firmly connected.
Incomplete con-
nection will interrupt the sound or cause noise,
Accidentai contact of bare unshielded wires wilf cause
excessive load on the amplifier and damage to the am-
plifier and speaker system
An incorrect polarity (+, ~-) connection of the left or
right speaker to the amplifier will not provide sufficient
bass for rich sound, disabling the normal stereo effect.
® Pay attention to the synthetic impedance in the case of
paraliel connection.
Extremely
low
impedance
will
cause amplifier darnage.
3.
If using an amplifier, as that for a musical instrument,
equipped with a phone jack as the output terminal,
use a commercially available standard cord with plug
to connect the speaker system,
Phone jack