AEONTEC ZW096 Manual - Página 5

Navegue en línea o descargue pdf Manual para Unidad de control AEONTEC ZW096. AEONTEC ZW096 9 páginas. Low-cost z-wave switch plugin module specifically used to enable z-wave command and control (on/off) of any plug-in too

Imprimir página
know how to do this, refer to its manual).
3. Press the Action button.
. If the remove success, Smart Switch LED will blink slowly. If Smart Switch LED still follows
that of load status, please repeat the process from step 2.
Short press 2
1. Send Security Node Info frame.
times
2. Add Smart Switch into an existing z-wave network:
1.
Insert the Smart Switch to power socket, The purple LED will blink slowly.
2. Let the primary controller into inclusion mode (If you don't know how to do this, refer to
its manual).
3. Press the Action Button.
. If the inclusion success, Smart Switch LED will keep turning on. Otherwise, the LED will
still blink slowly, in which you need to repeat the process from step 2.
3. Remove Smart Switch from an existing z-wave network:
1.
Insert the Smart Switch to power socket, The Smart Switch LED will follow the status
(on/off) of its load' power level.
2. Let the primary controller of existing Z-Wave network into remove mode (If you don't
know how to do this, refer to its manual).
3. Press the Action button.
. If the remove success, Smart Switch LED will blink slowly. If Smart Switch LED still follows
that of load status, please repeat the process from step 2.
Press and hold
Reset Smart Switch to factory Default:
20 seconds
1
. Make sure the Smart Switch has been connected to the power supply.
2. Press and hold the Z-wave button for 20 seconds.
3.
I
f holding time more than one second, the LED will blink faster and faster. If holding time
more than 20seconds, the purple LED will be on for 2 seconds, it indicates reset success,
otherwise please repeat step 2.
Note:
1, This procedure should only be used when the primary controller is inoperable.
2, Reset Smart Switch to factory default settings will: sets the Smart Switch to not in Z-
Wave network state; delete the Association setting, power measure value, Scene
Configuration Settings and restore the Configuration setting to the default.
4.2 RGB LED indication when Smart Switch is in Energy Mode