Aeotec TriSensor Manual del usuario - Página 11
Navegue en línea o descargue pdf Manual del usuario para Accesorios Aeotec TriSensor. Aeotec TriSensor 18 páginas.
Imprimir página
29-1-2019
2. Motion clear time.
This configures the clear time when your motion sensor times out and sends a no motion status.
Parameter #
Size
2
2
DEFAULT SETTING = 240
3. Motion sensitivity.
This setting configures the sensitivity of Motion Sensor where 0 is disabled, 1 is lowest sensitivity, and 11 is
maximum sensitivity.
Parameter #
Size
3
1
DEFAULT SETTING = 11
4. Enable/Disable Binary Sensor
This setting is used to enable Binary Sensor Reports which is used for gateways that use the older style of motion
reports. If you do not see status changes over your motion sensor, you must enable this setting.
Command Class
Command
Type
Event
Parameter #
Size
4
1
DEFAULT SETTING = 0
Group Association for direct control.
The TriSensor has 2 group control points to directly control Z-Wave devices without your gateway. Below is a table of
the available Group Association that you can set to the TriSensor to directly control your Z-Wave Switches and
Dimmers from within your gateway.
Group
Function
Association #
Motion Trigger = turn on device
2
No Motion Trigger = turn off device.
Temperature > Threshold = turn on
device.
3
Temperature <= Threshold = turn off
device.
What is a Group Association?
https://aeotec.freshdesk.com/support/solutions/articles/6000195459-trisensor-user-guide-
Value
1-32767
Value
0-11
COMMAND_CLASS_SENSOR_BINARY
SENSOR_BINARY_REPORT
MOTION (0x0C)
Detected (0xFF) / No-detected (0x00)
Value
0
1
TriSensor user guide. : Aeotec
Description
Clear/timeout time in seconds.
Description
Sets motion sensitivity.
Description
Disables Binary Sensor Report
Enables Binary Sensor Report
11/18