Aeotec ZW187 Manual del usuario - Página 3

Navegue en línea o descargue pdf Manual del usuario para Accesorios Aeotec ZW187. Aeotec ZW187 9 páginas. Recessed door sensor gen7
También para Aeotec ZW187: Manual (11 páginas)

Imprimir página
Aeotec ZW187 Manual del usuario

Quick start.

The installation of your Recessed Door Sensor has two key steps:
1. Install both parts of your sensor.
2. Connect your sensor to your Z-Wave network
Prepare the Main Sensor.
1. Press the sensor latch with a slotting screwdriver to remove the lid of the sensor.
2. Squeeze the sides of the sensor casing to alleviate pressure on the chipboard; slide the chipboard out. (It is
recommended that when pulling out the hardware from the plastic casing, pinch 2 sides parallel to the hardware to
relieve pressure when pulling the hardware out, it should make it far easier to remove the hardware or place it back
in).
3. Remove the Pull Tab to engage the pre-installed battery. LED will become slow fade-in fade-out Red color for a
few
seconds which will indicate that its power is on.