3Com Fast EtherLink XL PCI 10/100BASE-TX Manual de inicio rápido - Página 4
Navegue en línea o descargue pdf Manual de inicio rápido para Tarjeta de red 3Com Fast EtherLink XL PCI 10/100BASE-TX. 3Com Fast EtherLink XL PCI 10/100BASE-TX 17 páginas. Fast ethernet switching modules for the corebuilder 9000 enterprise switch
Imprimir página
4
100BASE-FX
AND
Handling Precautions
Unpacking
Instructions
10/100BASE-TX F
E
AST
THERNET
CAUTION: To prevent ESD-related damage:
Always wear an ESD wrist strap (not provided) when you
handle a Switching Module, ensuring that the strap makes good
skin contact.
Keep the Switching Module in its antistatic bag until you are
ready to install it.
When you handle the FEN Interface Module, follow these precautions:
Always handle the FEN Interface Module by the front panel only.
Do not touch the components, pins, leads, or solder connections.
Do not twist or otherwise force the module into the chassis when
you insert it into the module guides.
Before you push the module into the chassis, make sure that the
module ejector handles are open.
When you slide the module into place, match the upper and lower
module guides.
Use the following procedure when you unpack the Switching Module:
1 Verify that the Switching Module is the correct model by matching the
model number that is listed on the side of the shipping box to the
model number that you ordered (Model Number 3CB9LF10MC or
3CB9LF20R).
2 Remove the module, in its antistatic bag, from the shipping box.
3 Ensure that the box also contains:
Release Notes for the CoreBuilder 9000 Fast Ethernet
Switching Modules
100BASE-FX and 10/100BASE-TX Fast Ethernet Switching Modules
Quick Start Guide for the CoreBuilder 9000 Enterprise Switch (this
guide)
All shipping boxes are reusable. After you remove the contents, replace
the packing materials and store the shipping box for future use.
4 Remove the Switching Module from the antistatic bag and inspect it for
physical damage.
S
M
Q
WITCHING
ODULES
UICK
S
G
TART
UIDE