Aeotec MultiSensor 7 Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Sensores de seguridad Aeotec MultiSensor 7. Aeotec MultiSensor 7 8 páginas.
También para Aeotec MultiSensor 7: Manual del usuario (5 páginas)

Imprimir página

22/07/2021

3. It will be solid yellow during inclusion, and ﬂash white/green 3 times if paired successfully. If it fails, it will

ﬂash

/red

Advanced Functions.

Z-Wave Resetting MultiSensor 7.

Your MultiSensor can be removed from your Z-Wave network at any time. You'll need to use your Z-Wave network's

main controller to do this and the following instructions tell you how to do this. If you are using other products as your

main Z-Wave controller, please refer to the part of their respective manuals that tells you how remove devices from

your network.

Using an existing gateway:

You may need to refer to your gateway's method of including devices if you do not know how to pair a Z-Wave

device. You may use any gateway to perform an unpair/removal on MultiSensor 7 even if they are not paired

together to factory reset MultiSensor 7.

Z W

2. Tap the action button once; the purple led will light up.

3. If removed successful, the blue led will fade in and out to indicate it is ready to be paired to a new hub.

Manual Hard Resetting MultiSensor 7.

This method is not fully advised unless your gateway has failed, if paired to your network, performing these steps will

factory reset your MultiSensor 7, but may leave a hard to remove phantom/ghost device in your working Z-Wave

network.

1. Make sure the device has been powered.

2. Press and hold the button for 20 seconds. When the red led ﬂash, the device will enter factory reset mode.

https://aeotec.freshdesk.com/support/solutions/articles/6000232605-multisensor-7-user-guide

instead.

Z W

MultiSensor 7 user guide : Aeotec Help Desk

6/8