Ariston DN62X AUS Manual de instrucciones - Página 26
Navegue en línea o descargue pdf Manual de instrucciones para Horno Ariston DN62X AUS. Ariston DN62X AUS 28 páginas. Built-in multifunction double oven
Imprimir página
Care and Cleaning
Replacement of Oven Lamp
GB
! WARNING: Ensure that the appliance is switched
off before replacing the lamp to avoid the possibility
of electric shock.
The oven lamp is not covered by the guarantee. This
part is easy to replace:
1. Open the oven door and remove the rod shelves.
2. Grip the light glass dome, unscrew anti-
clockwise and lift out.
3. Reach into the aperture with fingers and unscrew
the faulty lamp anti-clockwise. Fit a replacement
lamp (15W 300°C SES) which can be obtained
from your nearest Service Centre (see Service),
and refit dome.
! When screwing and unscrewing the faulty lamp use
a thick cloth to protect your fingers should the lamp
break.
Switching off the electricity
! Turn off the mains switch before cleaning it and
during all maintenance operations.
• Before switching on again, ensure that all
controls are in the OFF position.
CLEANING THE DOORS
Take particular care not to damage the inner
surface of the door inner glass that is coated with
a heat reflective layer. Do not use scouring pads,
or abrasive powder, which will scratch the glass.
Ensure that the glass panel is not subjected to
any sharp mechanical blows.
Stubborn stains can be removed by using a fine
steel wool soap pad. For slight soiling the inner
glass panel may be cleaned, while still warm,
without removing it from the door. After cleaning,
rinse and dry with a soft cloth.
26
DROP DOWN DOORS
Remove the door inner glass as follows.
Remove screws from both side of door
Gently ease the top trim away from door
Gently ease glass upwards and remove from door
NEVER OPERATE THE COOKER WITHOUT THE
INNER DOOR GLASS IN POSITION.
Refit the door inner glass as follows.
1. Open the door fully.
2. Locate the inner door glass into its slots. The
inner door glass has a special reflective coating
on one side, in order to minimise surface
temperatures and energy consumption during
use, it is important it is fitted correctly.
3. Carefully slide the glass into its slots as far as it
will go and replace the top filler cap.