3Com 10G Manual de instalación - Página 4

Navegue en línea o descargue pdf Manual de instalación para Hardware de red 3Com 10G. 3Com 10G 4 páginas. Switch 4200g 10g interface module

(1): Switch

(3): Small cover plate (removed) in the middle on the filler panel

(4): Push-in direction

Figure 6 Installing a XENPAK optical module

Note: (1) Retain the small cover plate for future use.

(2) Do not tighten the module screws more than 0.4 Nm.

(3) The switch 4200G supports hot swapping of XENPAK

optical modules.

2.3 Removal

Step 1: Put on an ESD-preventive wrist strap and verify it is properly

grounded.

Step 2: Loosen the fastening screws at each side of the XENPAK optical

module using a screwdriver.

Step 3: Pull the XENPAK module until it comes out of the switch chassis.

3Com Corporation 350 Campus Drive

Marlborough, Massachusetts 01752-3064 USA

www.3Com.com

Part Number: 10014918 Rev. AA

Published July 2006

(2): Filler panels for optional module slots

(5): XENPAK Optical Module