Aeotec AEOEZW116 Manual de inicio rápido - Página 2
Navegue en línea o descargue pdf Manual de inicio rápido para Instrumentos de medida Aeotec AEOEZW116. Aeotec AEOEZW116 11 páginas. Single nano switch with measuring
También para Aeotec AEOEZW116: Manual (16 páginas)
Imprimir página
Prepare for Installation / Reset
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do
this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended
to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
Reset to factory default
This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only be used when the primary controller is inoperable.
Set Parameter 255
Safety Warning for Mains Powered Devices
ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the
assembly of the product, the voltage network has to be switched off and ensured against re-switching.
Installation
Notes for the wire connection ports:
N ? Power input for neutral
L ? Power input for live
IN ? Input for load power supply