Ariston HT 60 XA Manual de instrucciones - Página 4
Navegue en línea o descargue pdf Manual de instrucciones para Placa Ariston HT 60 XA. Ariston HT 60 XA 6 páginas.
Imprimir página
CARE AND MAINTENANCE
Cleaning the hob
• Before cleaning the cooking hob, disconnect it from mains power
supply and wait until it has cooled down.
• Important: never clean the appliance with steam cleaning equipment.
• Wipe it with a cloth moistened with hot water and soap or diluted liquid
detergent.
• Do not use abrasive or corrosive products, chlorine products or steel wool.
• Do not leave acid or alkaline substances, such as vinegar, salt or lemon
juice, etc., on the cooking hob.
Stainless steel surface
• Clean it with a specific commercial product.
Note: if the cooking hob is used continuously,the high temperatures
may alter the colour of the hotplates.
Cleaning the electric hotplates
The electric hotplates must be cleaned when they are lukewarm. Wipe
them with a cloth moistened with water and salt, and polish with a cloth
moistened with oil.
AFTER-SALES SERVICE
• Before contacting After-sales Service:
1. Re-start the cooking hob, to check whether correct operation has been
restored.
2. If the malfunction persists, call the After-sales Service.
Give the following information:
• type of malfunction;
• model of cooking hob;
• service number (i.e., the number that follows the word SERVICE on the
rating plate under the cooking hob and on the guarantee paper);
• your complete address;
• your telephone number and area code.
INSTALLATION
Technical information for installer
This cooking hob can be embedded in a worktop 20 to 50 mm thick.
If another appliance is not fitted under the cooking hob, insert a separator
panel, at a distance of at least 90 mm from the cooking hob bottom.
• If a vertical piece of furniture is installed, there must be a gap of at
least 100 mm between it and the edge of the cooking hob.
Installation of cooking hob
• Apply the supplied gasket to the cooking hob (unless it has already
been fitted), after having cleaned its surface as shown in the figure.
A - If the worktop is made out of wood, use the springs supplied.
A
1. Fit the 4 springs
into the relevant seat under the box.
2. Make an opening in the worktop, respecting the dimensions indicated in
the enclosed product description sheet.
3. Install the cooking hob in the worktop.
B- If the worktop is made out of marble or other materials (plastics, ceramics
or stone), the cooking hob must be fixed by means of brackets
from the After-sales Service (code 4819 310 18528).
1. Align the brackets with the bores and fix them with the screws.
2. Make an opening in the worktop, respecting the dimensions indicated in
the product description sheet.
3. Install the cooking hob in the worktop.
• Before installing the cooking hob, remove the plastic film that protects
it, if present. The outer surfaces of the furniture or appliances adjoining
the cooking hob must be heat resistant (heat protection "Y", according to
standards EN 60335-2-6).
• Installation must comply with current local safety regulations.
4
If any repairs are required, please contact an authorised After-sales Service
as indicated in the warranty. In the unlikely event that an operation or repair
is carried out by an unauthorised technician, always request a certification
of the job carried out and insist on the use of original spare parts. Failure
to comply with these instructions may compromise the safety and
quality of the product.
B
to be ordered