Whirlpool 220-240~volt Instrucciones de instalación - Página 3

Navegue en línea o descargue pdf Instrucciones de instalación para Lavadora Whirlpool 220-240~volt. Whirlpool 220-240~volt 5 páginas. Whirlpool washer lnstallation instructions 220/240-volt, 60-hz models
También para Whirlpool 220-240~volt: Manual de instrucciones de instalación y uso (18 páginas)

Imprimir página
Now start...
With washer in laundry area,
Numbers
correspond to
steps.
Read, then remove label that covers
drain connector.
Pull to completely
remove the shipping strap with 2 cotter
pins from the inside of the washer.
o remove the other
end of shipping strap from the back of
the washer. The shipping strap plug must
be completely
removed from the washer
for the self-leveling legs to be released.
Save the shipping strap for use in Step 16.
Use new hoses and washers that came
with your Whirlpool washer.
washer
Insert a flat washer into each end of the
inlet hoses. Check that washers are firmly
seated in couplings.
2. Squeeze ears of clamp with pliers to
open and place clamp over the
end of the drain hose.
3. While holding clamp open, work
end of drain hose onto drain
connector
until drain hose is within
l/4 inch (0.64 centimeters)
of ribbed
stop.
4. Position clamp over the drain hose
area marked "clamp."
Release
clamp. Clamp should be l/4 inch
(0.64 centimeters) from end of drain
n DO NOT FORCE EXCESS LENGTH OF
DRAIN HOSE DOWN THE STANDPIPE. THIS
COULD CAUSE SIPHONING.
I Attach hose to bottom inlet valve
opening first; then second hose to top
inlet. Tighten couplings by hand. Then use
pliers to make an additional
two-thirds
turn.
hose.
5
Open
n clamo and
slide over 'hook"
end of drain hose
to secure the rigid
and corrugated
sections together.
II
' II
8
Before attaching
water inlet
n hose, run water through both
faucets into a bucket.
This will get rid of
particles in the water lines that might clog
hoses. Mark which is the hot water faucet.
Floor Damage
Slide washer onto cardboard
or
hardboard before moving across floor.
Failure to do so may cause damage to
floor covering.
IMPORTANT: THIS PROCEDURE MUST BE
FOLLOWED TO ASSURE PROPER
INSTALLATION.
4
To prevent the drain hose from
n coming off or leaking, it must be
installed per the following instructions:
1, Wet the inside end of the drain hose
with tap water. DO NOT USE ANY
OTHER LUBRICANT.
Panel B
coupling
washer
9
Attach bottom hose (inlet marked
n 'H") to hot water faucet. Attach
top hose (inlet marked 'C") to cold water
faucet. Tighten couplings to faucet by
hand; then use pliers to make final two-
thirds turn,
6
Move washer close to final
n position. Put "hook" end of drain
hose into laundry tub or standpipe.
Check for proper length of drain hose.