Whirlpool 3950310 Manual de uso y mantenimiento - Página 14

Navegue en línea o descargue pdf Manual de uso y mantenimiento para Lavadora Whirlpool 3950310. Whirlpool 3950310 20 páginas. Three speed automatic washers

TROUBLESHOOTING
C
OMMON WASHING PROBLEMS
Problem ...
Washer makes noise
(cont.)
Won't fill/rinse/agitate
or wrong temperature
Washer stops
Agitator operation
Water level seems
too low or washer
not completely filling
Washer tub is crooked
14
CONT
(
Cause ...
Gears engaging after drain and
before spin.
Upper part of agitator clicks during wash.
Power cord not plugged in.
Timer dial is not lined up.
Water inlet valve screens are plugged.
Water is turned off.
Hot and cold hoses are reversed.
Inlet hose is kinked.
Power cord not plugged in.
No power at plug.
Fuse blown or circuit breaker open.
Using an extension cord.
Timer dial is not lined up.
Timer knob not pulled out.
Washer at pause in Permanent Press
cycle (approximately 2 minutes).
Machine is overloaded.
The top of the agitator moves only in one
direction.
The top of the agitator is loose.
The top of the agitator is much higher
than the highest water level. This creates
a perception of the washer not being full.
Tub is pulled forward when unloading.
Tub moves.
Unit not level.
.
)
Solution ...
This is normal.
This is normal.
Plug in power cord.
Turn timer knob to the right
slightly and pull to start.
Clean screens.
Turn on water.
Reverse hoses.
Straighten hoses.
Plug in power cord.
Check electrical source or call
electrician.
Replace fuse or reset circuit
breaker. If problem continues,
call electrician.
Do not use extension cords.
Turn timer to the right slightly
and pull to start.
Set and pull out knob.
Allow cycle to continue.
Wash smaller loads.
This is normal.
This is normal.
This is normal.
Push tub to center before
starting.
This is normal.
Ensure front feet are installed
and nuts tightened. Level
washer. Reset rear leveling legs.
See Installation Instructions.