Whirlpool 6AWTW5700XW0 Manual de uso y mantenimiento - Página 11
Navegue en línea o descargue pdf Manual de uso y mantenimiento para Lavadora Whirlpool 6AWTW5700XW0. Whirlpool 6AWTW5700XW0 20 páginas. Top-loading high efficiency low-water washer
Imprimir página
9.
Select cycle options
Select any other cycle options you may wish to add, if not
previously set. Some cycles will automatically add certain
options such as Deep Clean or Extra Rinse. These can be
turned off, if desired.
NOTE: Not all options are available with all cycles.
10.
Press START/Pause/Unlock to
begin wash cycle
Press the START/Pause/Unlock button to start the wash cycle.
When the cycle has finished, the DONE indicator will light and
the end of cycle signal will sound (if set). Promptly remove
garments after cycle has completed to avoid odor, reduce
wrinkling, and rusting of metal hooks, zippers, and snaps.
Unlocking the lid to add garments:
If you need to open the lid to add 1 or 2
missed garments:
Press START/Pause/Unlock; the lid will unlock
once the washer movement has stopped.
This may take several minutes if the load
was spinning at high speed. Then close
lid and press START/Pause/Unlock again
to restart the cycle.
If lid is left open for more than 10 minutes the water will
pump out automatically.
WASHER MAINTENANCE
WATER INLET HOSES
Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Periodically inspect and replace inlet hoses
if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of
replacement on the label with a permanent marker.
CLEANING YOUR WASHER
Keep your washer as clean and fresh as your clothes.
To keep washer interior odor-free, follow this recommended
monthly cleaning procedure:
1. Make sure the washer is empty.
2. If using liquid chlorine bleach, add 1 cup (250 mL)
to liquid chlorine bleach dispenser.
IMPORTANT: Do not add detergent to CLEAN WASHER
cycle. Do not use more than recommended amount of
bleach to avoid damaging product over time.
3. Close washer lid.
4. Press POWER.
5. Select CLEAN WASHER cycle.
6. Press START/Pause/Unlock. Water will pour into
washer for a moment and pause, lid will lock, then
cycle will continue.
NOTE: For best results, do not interrupt cycle. If cycle must
be interrupted, press POWER and run a RINSE AND SPIN
cycle to ensure cleaner or bleach have been rinsed from
washer.
To clean exterior:
1. Use a soft, damp cloth or sponge to wipe up any spills.
2. Use all-purpose surface cleaner, if needed.
IMPORTANT: To avoid damaging the washer's finish,
do not use abrasive products.
11