Whirlpool AWM 5100 Manual de instrucciones - Página 17

Navegue en línea o descargue pdf Manual de instrucciones para Lavadora Whirlpool AWM 5100. Whirlpool AWM 5100 19 páginas.

Worktop for built-under models

The appliance must only be installed beneath a continuous fitted kitchen worktop.

If the appliance will be built under it is mandatory to use the cover panel UBS. This can be obtained

from specialist shops or from After-Sales Service.

1.Unplug the appliance.

2.Unscrew the worktop fixing screws from the rear of the appliance.

3.Slide the worktop fully backward and lift it upwards to remove. Install the cover panel following the

relative instructions.

4.Refit the fixing screws and tighten them.

5.Plug the appliance only into the mains power socket.

Connect the water inlet hose

For models with straight hose "A"

1.Insert the dirt strainer (already premounted on the

hose end or included in the accessories) into the

threaded tap coupling.

2.Carefully screw the hose connection onto the tap

preferably by hand.

3.Make sure there are no kinks in the hose.

4.Check water-tightness of tap and appliance connections

by turning the tap completely on.

If the hose is too short, replace it with a suitable length

of pressure resistant hose (1000 kPa min, EN 50084

approved type).

Periodically check the hose for brittleness and cracks and

replace if necessary.

The appliance can be connected without an anti-

backpressure valve.

For models with Water Stop hose "B"

If the flexible hose is damaged, unplug the appliance from

the mains immediately.

1.Screw the threaded connector with the filter inserted

onto the tap.

2.Check water-tightness of tap and appliance connections

by turning the tap completely on.

If the hose is too short, replace it with a 3 m Water Stop

hose (available from After-Sales Service or from your

dealer). This operation must be carried out exclusively by

a licensed electrician.

The appliance must not be connected to the mixing tap

of a non-pressurized water heater.

The inlet hose and the plastic enclosure at the tap

connection contain electrical components. Do not cut the

hose and do not immerse the plastic enclosure in

water.