Whirlpool WASHER Manual de instrucciones de instalación - Página 3

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Lavadora Whirlpool WASHER. Whirlpool WASHER 8 páginas. Washing machine
También para Whirlpool WASHER: Manual de instrucciones de instalación (16 páginas), Manual de instrucciones de instalación (27 páginas), Instrucciones de uso (8 páginas), Instrucciones de uso (20 páginas), Instrucciones de uso (24 páginas), Instrucciones de uso (8 páginas), Manual de instrucciones de instalación (20 páginas), Instrucciones de uso (15 páginas), Manual de uso y mantenimiento (40 páginas), Manual de instrucciones de instalación (16 páginas), Instrucciones de uso (8 páginas), Cuadro de programas (2 páginas), Instrucciones de instalación (5 páginas)

Imprimir página

Whirlpool WASHER Manual de instrucciones de instalación

Location Requirements

Selecting the proper location for your washer improves

performance and minimizes noise and possible washer "walk."

Your washer can be installed in a basement, laundry room, closet,

or recessed area. See "Drain System."

IMPORTANT: Do not install or store the washer where it will be

exposed to the weather.

Proper installation is your responsibility.

You will need:

A water heater set to deliver 49°C (120°F) water to the washer.

An earthed electrical outlet located within 1.2 m (4 ft) of where

the power cord is attached to the back of the washer. See

"Electrical Requirements."

Hot and cold water faucets located within 90 cm (3 ft) of the

hot and cold water fill valves, and water pressure of 34.5-

690 kPa (5-100 psi). Washers with triple dispensers require

138-690 kPa (20-100 psi) for best performance.

A level floor with a maximum slope of 2.5 cm (1") under entire

washer. Installing the washer on carpeting is not

recommended.

A sturdy floor to support the washer weight (washer, water

and load) of 143 kg (315 lbs).

Do not store or operate your washer in temperatures at or below

0°C (32°F). Some water can remain in the washer and can cause

damage in low temperatures. See "Washer Care" in the Washer

User Instructions for winterizing information.

Recessed area or closet installation

The dimensions shown are for the recommended spacing allowed

(A and B), except the closet door ventilation openings. The

dimensions shown for the closet door ventilation openings (C) are

the minimum required.

48.3 cm

(19")

0 cm

68.6 cm

(0")

2.5 cm

(27")

(1")

A. Front view

B. Side view

C. Closet door with vents

Additional spacing should be considered for ease of

installation and servicing.

Additional clearances may be required for wall, door and floor

moldings.

Additional spacing of 2.5 cm (1") on all sides of the washer is

recommended to reduce noise transfer.

If a closet door is installed, the minimum air openings in the

top and bottom of the door are required (C). Louvered doors

with air openings in the top and bottom are acceptable.

Companion appliance spacing should also be considered.

35.6 cm

(14" max.)

310 cm

(48 in. )

155 cm

(24 in. )

64.8 cm

10.2 cm

¹⁄ ₂

(25

(4")

The washer can be installed using the standpipe drain system

(floor or wall), the laundry tub drain system, or the floor drain

system. Select the drain hose installation method you need. See

"Tools and Parts."

Standpipe drain system - wall or floor (views A & B)

The standpipe drain requires a minimum diameter standpipe of

5 cm (2"). The minimum carry-away capacity can be no less than

64 L (17 gal.) per minute. A 5 cm (2") diameter to 2.5 cm (1")

diameter standpipe adapter kit is available. See "Tools and Parts."

The top of the standpipe must be at least 99 cm (39") high and no

higher than 244 cm (96") from the bottom of the washer.

Laundry tub drain system (view A)

The laundry tub needs a minimum 76 L (20 gal.) capacity. The top

of the laundry tub must be at least 244 cm (96") above the floor

and no higher than 244 cm (96") from the bottom of the washer.

Floor drain system (view B)

The floor drain system requires a siphon break that may be

purchased separately. See "Tools and Parts."

The siphon break must be a minimum of 71 cm (28") from the

7.6 cm

bottom of the washer. Additional hoses might be needed.

(3")

7.6 cm

(3")

Drain System

99 cm

(39")

71 cm

99 cm

(28")

(39")