Whirlpool 3ET22DK Manual de uso y mantenimiento - Página 6
Navegue en línea o descargue pdf Manual de uso y mantenimiento para Frigorífico Whirlpool 3ET22DK. Whirlpool 3ET22DK 26 páginas. No-frost refrigerator-freezers
También para Whirlpool 3ET22DK: Manual de uso y mantenimiento (20 páginas), Manual de uso y mantenimiento (16 páginas)
Imprimir página
Before Using Your
Refrigerator
In This Section
Page
Page
Cleaning
your refrigerator
. . . . . . . . . . . . . . . . . 5
Installing
it properly
. . ..-......................
6
Plugging
it in . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Leveling
it . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it and level it.
Cleaning
your
refrigerator
Removing
packaging
materials
NOTE: Do not remove any permanent
-
Remove tape and any inside labels (except
the model and serial number label) before
using the refrigerator.
To remove any remaining
glue:
l
Rub briskly with thumb to make a ball, then
remove.
OR
l
Soak area with liquid hand-dishwashing
detergent before removing glue as
described above. Do not use sharp
instruments,
rubbing alcohol, flammable
fluids or abrasive cleaners. These can
damage the material. See "Important
Safety Instructions"
on page 3.
instruction labels inside your refrigerator. Do
not remove the Tech Sheet fastened under
the refrigerator at the front.
Cleaning
it before
use
After removing all packaging materials,
clean your refrigerator before using it, if
necessary. See cleaning instructions
on
pages 17-18.
Plugging
it in
Recommended
Grounding
Method
A 115 Volt, 60 Hz (Plug 1) or 220/240 Volt,
50 Hz (Plug 2), AC only 15 or 20 ampere
fused and properly grounded electrical
supply is required. It is recommended
that a
separate circuit serving only this appliance
be provided. Use a receptacle which cannot
be turned off with a switch or pull chain. Do
not use an extension cord.
60
q@
080 0
q
88
9'LJ
w \B 0 0
Plug
1
Plug 2
5