Whirlpool WUR50X24EM Manual de uso y mantenimiento - Página 6

Navegue en línea o descargue pdf Manual de uso y mantenimiento para Frigorífico Whirlpool WUR50X24EM. Whirlpool WUR50X24EM 32 páginas. Under counter refrigerator

Imprimir página

10. Align the top hinge washer with the hinge hole in the top of

the door. Then, insert the top hinge pin through the washer

and into the hinge hole.

11. Fasten the top hinge cover with three screws and move the

remaining four screws to the opposite side. Completely

tighten the seven screws.

A. Top hinge washer

B. Top hinge

Door Closing

Your refrigerator has four leveling legs. If your refrigerator seems

unsteady or you want the door to close more easily, adjust the

refrigerator's tilt using the instructions below.

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

1. Plug into a grounded 3 prong outlet.

WARNING

Excessive Weight Hazard

Use two or more people to move and install

refrigerator.

Failure to do so can result in back or other injury.

2. Move the refrigerator into its final location.

3. Turn the leveling legs to the right to lower the refrigerator or

turn the leveling legs to the left to raise it. It may take several

turns of the leveling legs to adjust the tilt of the refrigerator.

NOTE: Having someone push against the top of the

refrigerator takes some weight off the leveling legs. This

makes it easier to adjust the leveling legs.

6 6 6 6 6 6 6 6 6 6 6 6

4. Open the door again to make sure that it closes as easily

as you like. If not, tilt the refrigerator slightly more to the rear

by turning both front leveling screws to the left. It may take

several more turns, and you should turn both leveling legs

the same amount.

Base Grille

Tools Needed: Phillips screwdriver

Remove the Base Grille

1. Open the refrigerator door.

2. Using a Phillips screwdriver, remove the two screws. Push

both tabs in toward the center to release the base grille from

the refrigerator.

3. Remove the base grille.

Replace the Base Grille

1. Open the refrigerator door.

2. Position the base grille so that both tabs align and the

base grille snaps into place. Replace the two screws.

Tighten the screws.

REFRIGERATOR USE

Normal Sounds

Your new refrigerator may make sounds that your old one

didn't make. Because the sounds are new to you, you might be

concerned about them. Most of the new sounds are normal. Hard

surfaces, such as the flooring and surrounding structures, can

make the sounds seem louder. The following describes the kinds

of sounds and what may be making them.

■

Your refrigerator is designed to run more efficiently to keep

your food items at the desired temperatures and to minimize

energy usage. The high efficiency compressor and fans may

cause your refrigerator to run longer than your old one. You

may also hear a pulsating or high-pitched sound from the

compressor or fans adjusting to optimize performance.

■

Rattling noises may come from the flow of refrigerant or

items stored inside the refrigerator.

A. Tabs

B. Screws