Clam EDGE Manual de funcionamiento y piezas - Página 2

Navegue en línea o descargue pdf Manual de funcionamiento y piezas para Césped y jardinería Clam EDGE. Clam EDGE 8 páginas. Power augers

Please follow these Important safety precautions regarding your

1. This product is solely intended for use in drilling holes in the ice. It should be handled and used with

caution as there are very sharp edges on the blades and a spinning auger during use that could

cause bodily harm if not used properly.

2. Keep all articles of clothing as well as body parts away from the powerhead and spinning auger

during operation at all times. Your auger is a tool that should be handled with caution.

3. This product should not be altered in any way from its original, purchased condition unless with an

authorized Clam accessory or part. Using parts other than from Clam could be potentially damaging

to the product or dangerous to the user, and will void all warranties by the manufacturer.

4. Person(s) using this auger should weigh a minimum of 100 lbs., and not be under the influence of

any chemicals or mind-altering substances. The Edge auger operates with a lot of torque and speed,

and the operator must be fully aware and prepared for that during its use.

5. If by any chance, something is not in proper working condition on your auger-recoil, auger, throttle,

etc..., do not use it. Bring it to an authorized service center for repair.

6. Verify all hardware-especially the 4 bolts on the blades and the one socket head bolt holding the

auger to the powerhead, are secure prior to usage.

7. If by any chance, the auger stops spinning during cutting, release the throttle and pull up on the

auger to release the torque. Then reapply the throttle and continue drilling.

8. When the auger is not in use, turn off the power by pressing the stop switch. Do not let it run while

leaving your auger unattended.

Clam Edge auger during use