Whirlpool 27' Ayuda al empleo - Página 20

5. Slide top across dryer so that rear is under back

brackets and front fits into front clips.

6. Reinstall three dryer top screws.

7. Close console.

8. Reinstall the two console screws.

Replacing the Drum Lamp

1. Open dryer door. Remove the drum lamp cover screws. (Fig. 17)

2. Lift and slide off the drum lamp cover.

3. Tip the light socket forward and remove the bulb. (Fig. 18)

4. Put new bulb into place.

5. Slide drum light cover back into place. Reinstall the drum light cover screw. Close dryer door.

Fig. 17

1. Remove the dryer top.

2. Open the dryer door and remove the two (2) screws securing the door switch to the front

panel.

3. Disconnect the wiring harness connectors from the door switch terminals.

4. Remove the door switch assembly.

1. Using a blade screwdriver, locate and release the two toe panel clips, approximately 4" in from

each side. (Fig. 19)

2. Pull toe panel off and set finished side up.

Fig. 18

Fig. 16

Fig. 19