Whirlpool 27' Manual de instrucciones de instalación - Página 10

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Secadora Whirlpool 27'. Whirlpool 27' 22 páginas. Microwave oven and thermal oven
También para Whirlpool 27': Ayuda al empleo (36 páginas), Manual de instrucciones de instalación (11 páginas), Manual de instrucciones de instalación (11 páginas), Manual de instrucciones de instalación (48 páginas), Manual de instrucciones de instalación (27 páginas), Manual de instrucciones de instalación (32 páginas), Manual de instrucciones de instalación (12 páginas), Instrucciones de instalación (5 páginas)

Imprimir página
Whirlpool 27' Manual de instrucciones de instalación

Venting Requirements

WARNING:
To reduce the risk of re, this dryer MUST BE
EXHAUSTED OUTDOORS.
IMPORTANT:
Observe all governing codes and ordinances.
Dryer exhaust must not be connected into any gas vent,
chimney, wall, ceiling, attic, crawlspace, or a concealed space
of a building. Only rigid or exible metal vent shall be used for
exhausting.
4" (102 mm) heavy metal exhaust vent
Only a 4" (102 mm) heavy metal exhaust vent and clamps
may be used.
Do not use plastic or metal foil vent.
Rigid metal vent:
Recommended for best drying performance and to avoid
crushing and kinking.
Flexible metal vent:
(Acceptable only if accessible to clean)
Must be fully extended and supported in nal dryer location.
Remove excess to avoid sagging and kinking that may result
in reduced air ow and poor performance.
Do not install in enclosed walls, ceilings, or oors.
The total length should not exceed 7
NOTE:
If using an existing vent system, clean lint from entire
length of the system and make sure exhaust hood is not
plugged with lint. Replace plastic or metal foil vents with rigid
metal or exible metal vents. Review "Vent System Chart" and,
if necessary, modify existing vent system to achieve best drying
performance.
10

VENTING

4"
(102 mm)
3
/
ft. (2.4 m).
4
Exhaust hoods:
Must be at least 12" (305 mm) from ground or any object
that may obstruct exhaust (such as owers, rocks, bushes,
or snow).
Recommended Styles:
Louvered hood
Acceptable Style:
Angled hood
Elbows:
45° elbows provide better air ow than 90° elbows.
Good
Clamps:
Use clamps to seal all joints.
Exhaust vent must not be connected or secured with screws
or other fastening devices that extend into interior of duct
and catch lint. Do not use duct tape.
See "Venting Kits" for more information.
Box hood
Better