Whirlpool 3LWED4900YW Manual - Página 11

Navegue en línea o descargue pdf Manual para Secadora Whirlpool 3LWED4900YW. Whirlpool 3LWED4900YW 30 páginas.

Imprimir página

The Vent System Chart provides venting requirements that

will help achieve best drying performance.

Vent System Chart

Number of

Type

90° turns

of vent

or elbows

Rigid metal

NOTE: Side and bottom exhaust installations have a 90° turn

inside the dryer. To determine maximum exhaust length, add

one 90° turn to the chart.

The maximum length using a 51 mm x 152 mm (2"x 6")

rectangular vent with 2 elbows and a 64 mm (2-1/2") exhaust

hood is 2,4 m (8ft).

For exhaust systems not covered by the Vent System Chart (such

as multiple unit hookups, plenums, and power-assist fans), see

Service Manual, Part 603197. (To purchase the Service Manual,

contact your local authorized service dealer.

INSTALL VENT SYSTEM

Install exhaust hood

Install exhaust hood and use caulking compound to seal

exterior wall opening around exhaust hood.

Box/louvered

Angled

hoods

15,8 m (52 ft.)

13,4 m (44 ft.)

11,0 m (36 ft.)

18,5 m (28 ft.)

8,2 m (27 ft.)

6,4 m (21 ft.)

6,1 m (20 ft.)

4,3 m (14 ft.

Connect vent to exhaust hood

Vent must t over the exhaust hood. Secure vent to exhaust

hood with 102 mm (4") clamp. Run vent to dryer location

using straightest path possible. Avoid 90° turns. Use clamps

to seal all joints. Do not use duct tape, screws, or other

fastening devices that extend into interior of vent to secure

vent, because they can catch lint.

CONNECT VENT

Connect vent to exhaust outlet

Using a 102 mm (4") clamp, connect vent to exhaust outlet

in dryer. If connecting to existing vent, make sure vent is

clean. Dryer vent must t over dryer exhaust outlet and inside

exhaust hood. Check that vent is secured to exhaust hood

with a 102 mm (4") clamp.

Move dryer to nal location

Move dryer to nal location. Avoid crushing or kinking vent.

After dryer is in place, remove corner posts and cardboard

from under the dryer.