Whirlpool 3RAWZ481G Manual de uso y mantenimiento - Página 7
Navegue en línea o descargue pdf Manual de uso y mantenimiento para Secadora Whirlpool 3RAWZ481G. Whirlpool 3RAWZ481G 24 páginas. Electric and gas dryer
También para Whirlpool 3RAWZ481G: Manual de uso y mantenimiento (28 páginas), Manual de instrucciones de instalación (25 páginas)
Imprimir página
2. Turn the Cycle Control knob to the recommended cycle for
the type of load being dried.
3. Select a temperature setting with the Temperature selector.
The cycle descriptions include temperature setting
suggestions.
4. (OPTIONAL) Select the End of Cycle Signal if desired. The
signal is helpful when drying permanent press or synthetics.
Promptly remove these items from the dryer at the end of the
cycle to prevent wrinkles.
5. Push the Start button. Your gas dryer has an electronic
ignition system for the burner which is fully automatic; no
action is needed by the user (there is no pilot light).
NOTE: Your dryer stops automatically when a cycle ends.
Stopping and Restarting
You can stop your dryer any time during a cycle.
To stop your dryer
Open the dryer door or turn the Cycle Control knob to an Off
position.
NOTE: The Cycle Control knob should point to an Off area when
the dryer is not in use.
To restart your dryer
1. Close the door.
2. Select a new cycle and temperature (if desired).
3. Push the Start button.
Load clothes loosely into the dryer. Do not pack the dryer. Allow
space for clothes to tumble freely. The following chart shows
examples of balanced loads that would allow for proper tumbling.
Heavy work
4 pair of trousers, 4 pair of jeans, 2
clothes
sweatshirts, 2 sweatpants, 4 shirts
Delicates
3 blouses, 1 robe, 4 slips,
8 undergarments, 2 sets of sleepwear,
1 child's outfit
Towels
10 bath towels, 10 hand towels,
14 washcloths, 1 bath mat
Mixed Load
3 sheets (1 king, 2 twin), 4 pillowcases,
9 T-shirts, 9 pair of shorts, 3 blouses
10 handkerchiefs, 3 shirts
Drying, Cycle, and Temperature Tips
Select the correct cycle and temperature for your load.
Cool Down tumbles the load without heat during the last few
minutes of all cycles to make the load easier to handle.
Drying tips
Follow care label directions when they are available.
If desired, add a fabric softener sheet. Follow package
instructions.
Remove the load from the dryer as soon as tumbling stops to
reduce wrinkling. This is especially important for permanent
press, knits, and synthetic fabrics.
Loading
Cycle and temperature tips
Use a High Heat setting for drying heavyweight items such as
towels and work clothes.
Use a Medium Heat setting for drying medium weight items,
such as sheets, underwear, permanent press fabrics, and
some knits.
Use a Low Heat setting for drying lightweight items such as
lingerie, blouses, dresses, and some knits.
Use a no-heat (air) setting for rubber, plastic, or heat-sensitive
fabrics.
Line dry bonded or laminated fabrics.
NOTE: If you have questions about drying temperatures for
various loads, refer to the care label directions. If you are unsure
of the temperature to select for a load, select a lower setting
rather than a higher setting.
Dryer Symbols
The control panel of your dryer contains symbols. Refer to the
chart below for a definition of those symbols.
Temperature Selector
Low
Heat
Start Button
End of Cycle Signal Selector
End of Cycle
Signal On
Cycle Control Knob
Automatic Drying Cycles
Heavyweight Items
Cupboard Dry
Synthetics/
Permanent Press
Delicates
Iron Dry
Continued on next page.......
Medium
High
Heat
Heat
End of Cycle
Signal Off
Cupboard Dry Plus
Cotton
Quick Dry
Cool Down
Machine Off
7