Whirlpool 8527813 Manual de instrucciones de instalación - Página 12

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Secadora Whirlpool 8527813. Whirlpool 8527813 13 páginas. Commercial stacked dryer gas & electric

Imprimir página
Recessed area and
closet installation
instructions
This dryer may be installed in a
recessed area or closet. For recessed
area and closet installations,
minimum clearances can be found
on the serial tag on the dryer.
The installation spacing is in inches
and is minimum allowable. Additional
spacing should be considered for
ease of installation, servicing and
compliance with local codes and
ordinances.
If closet door is installed, the minimum
unobstructed air openings in top and
bottom is required. Louvered doors
with equivalent air openings are
acceptable.
Companion appliance spacing
should be considered.
The dryer must be exhausted outdoors.
No other fuel-burning appliance may
be installed in the same closet.
Minimum Installation Clearances
Back
Sides
Recessed
0 in
0 in
(0 cm)
(0 cm)
(15.2 cm)
Closet
0 in
0 in
(0 cm)
(0 cm)
(0 cm)
0" (0 cm)
0"
(0 cm)
closet
door
7"
(17.8 cm)
0" (0 cm)
Closet Side View
Recessed Front View
Additional clearances may be required for
wall, door and floor moldings if external
exhaust elbow is used.
48" sq. in.
(310 sq. cm)
Front
closet
View
door
24" sq. in.
(155 sq. cm)
Opening is minimum for closet door. Louvered
door with equivalent air openings is acceptable.
Companion appliance spacing should be
considered.
Part No. 8527813
© 2001 Whirlpool Corporation
Maintenance
instructions
• Clean lint screen after each cycle.
• Keep dryer area clear and free from
combustible materials, gasoline and
other flammable vapors and liquids.
• Do not obstruct the flow of
combustion and ventilation air.
Removing
accumulated lint
From Inside the Dryer Cabinet.
Lint should be removed every 2 years
of more often, depending on dryer
usage. Cleaning should be done by a
qualified person.
From the Exhaust Vent.
Lint should be removed every 2 years,
or more often, depending on dryer
usage.
Moving the dryer
Top
Front
to a new location...
6 in
—
0 in
7 in
Slide dryer onto cardboard or
(17.8 cm)
hardboard before moving across floor
to avoid damaging floor covering.
Gas dryer models:
• Disconnect electrical cord. Tape
6"
(15.2 cm)
securely to dryer.
• Shut off the gas supply valves in the
gas supply line.
• Disconnect gas pipe and fittings
from dryer and cap gas supply line.
Tape end of dryer gas pipe.
Electric dryer models:
• Shut off electrical supply to dryer.
0"
• Disconnect the power supply cord
(0 cm)
or cable from the dryer terminal
block.
All models:
• Make sure leveling legs are secure
in dryer base.
3" (7.6 cm)
• Tape dryer door, lint screen and
end of gas pipe.
Before the appliance is removed from
service or discarded, remove the
door to the dryer compartment.
3" (7.6 cm)
Prepared by Whirlpool Corporation, Benton Harbor, Michigan 49022
If dryer does not
operate properly...
Check the following to be sure that:
1. Electric supply is connected.
2. Circuit breakers are not tripped or
house fuses blown.
3. Door is closed.
4. Controls are set in a running or "ON"
position.
5. Start button has been pushed firmly.
6. For gas dryers, check that gas supply
shutoff valves are set in open
position.
If you need
assistance...
The Whirlpool Consumer Interaction
Center will answer any questions
about operating or maintaining your
dryer not covered in the Installation
Instructions. The Whirlpool Consumer
Interaction Center is open 24 hours
a day, 7 days a week. Just dial
1-800 NO BELTS (1-800-662-3587) —
the call is free.
When you call, you will need the dryer
model number and serial number.
Both numbers can be found on the
serial-rating plate located on your
appliance.

Product dimensions

top
exhaust
BACK
VIEW
bottom
exhaust
SIDE
VIEW
door
23-3/4"
29-1/4"
(60.3 cm)
(74.3 cm)
Printed in U.S.A.
13-1/2"
(34.3 cm)
41"
(104.1 cm)
27" (68.6 cm)
76-3/4"
(195 cm)
approx. 1"
(2.5 cm)