Whirlpool CGW9100VQ0 Manual de instalación - Página 18

Navegue en línea o descargue pdf Manual de instalación para Secadora Whirlpool CGW9100VQ0. Whirlpool CGW9100VQ0 40 páginas. Commercial dryer- gas or electric

Imprimir página

DirectWire,

4-wireconnection:

IMPORTANT: A 4-wire connection is required for mobile

homes and where local codes do not permit the use of 3-

wire connections,

Direct wire cable must have 5 ft (1.52 m)

so dryer can be moved

if needed.

Strip 5" (12.7 cm) of outer

covering from end of cable,

leaving bare ground wire at 5"

(12.7 cm). Cut 11Z2 ' ' (3.8 cm)

from 3 remaining wires. Strip

insulation back 1" (2.5 cm).

Shape ends of wires into a

hook shape.

of extra length

When connecting to the terminal block,

place the hooked end of the wire under the

screw of the terminal block (hook facing

right), squeeze hooked end together and

tighten screw, as shown.

Remove center silver-colored terminal

block screw.

Remove neutral ground wire from external ground

conductor screw. Connect neutral ground wire and

place the hooked end (hook facing right) of the neutral

wire (white or center wire) of direct wire cable under

the center screw of the terminal block. Squeeze

hooked ends together. Tighten screw.

3. Connect ground wire (green

or bare)

of direct wire

cable to external ground

conductor screw. Tighten

screw.

4. Place the hooked ends of

the other direct wire cable

wires under the outer

terminal block screws

(hooks facing right). Squeeze hooked ends together.

Tighten screws.

5. Tighten strain relief screw.

6. Insert tab of terminal block cover into slot of dryer rear

panel. Secure cover with holddown screw.

7. You have completed your electrical connection. Now

go to "Venting Requirements."

A. External ground conductor screw

B. Ground wire (green or bare) of power supply cable

C. '3/4"(1.9 cm) UL listed strain relief

D. Center silver-colored terminal block screw

E. Neutral ground wire

E Neutral wire (white or center wire)

A. External ground conductor screw - Dotted line shows

position of NEUTRAL ground wire before being moved

to center silver-colored terminal block screw.

B. Center silver-colored terminal block screw

C. Neutral ground wire

D. Neutral wire (white or center wire)

E. 3/4"(1.9 cm) UL listed strain relief