Whirlpool Duet GGW9200LQ0 Manual de uso y mantenimiento - Página 14
Navegue en línea o descargue pdf Manual de uso y mantenimiento para Secadora Whirlpool Duet GGW9200LQ0. Whirlpool Duet GGW9200LQ0 48 páginas. Electronic gas dryer
Imprimir página
4=
5=
Insert the new handle into the side opening of the door. Make
sure the handle seats all the way in, and the holes line up with
the holes in the door. Reattach with 2 screws.
Use a small flat-head screwdriver to remove hole plugs in the
door opening. Slide the head of the screwdriver under the
cap of each hole plug, being careful not to scratch the dryer
surface. Lift up. Remove the hole plugs in the door opening
and insert in the opposite side.
6=
Insert a screw in the second opening from the top of the
hinge opening and partially tighten. Hang the door by placing
the top hinge keyhole over the second screwhead and tighten
the screw. By putting this screw in first, the door will hang in
place while you insert and tighten the remaining 4 screws.
/
Install new handle filler and hinge cover
1. Using the new handle filler provided in the reversing kit, hook
the top of the handle filler onto the loosened upper door trim.
Snap the joined pieces into place. You may need to use the
heel of your hand to firmly snap the pieces back into place.
2. Hook the bottom of the handle filler onto the lower door trim
and snap into place.
3. Repeat steps 1 and 2 to install the hinge cover on the
opposite side.
4. Close the door and check that it latches securely.
2=
3.
4.
5=
6.
7.
8=
9.
10.
11.
Check to be sure all parts are now installed. If there is an
extra part, go back through the steps to see which step was
skipped.
Check to be sure you have all of your tools.
Dispose of all packaging materials.
Check the dryer's final location. Be sure the vent is not
crushed or kinked.
Check to be sure the dryer is level. (See "Level Dryer.")
Plug into a grounded 3 prong outlet. Turn power on.
Remove the blue protective film on the console and any tape
remaining on the dryer.
Read "Dryer Use."
Wipe the dryer drum interior thoroughly with a damp cloth to
remove any dust.
Set the dryer on a full heat cycle (not an air cycle) for 20
minutes and start the dryer.
If the dryer will not start, check the following:
•
Dryer is plugged into a grounded 3 prong outlet.
•
Electrical supply is connected.
•
House fuse is intact and tight; or circuit breaker has not
tripped.
•
Dryer door is closed.
When the dryer has been running for 5 minutes, open the
dryer door and feel for heat. If you do not feel heat, turn the
dryer off and check to see if the gas supply line shutoff valve
is open.
•
If the gas supply line shutoff valve is closed, open it, then
repeat the 5-minute test as outlined above.
•
If the gas supply line shutoff valve is open, contact a
qualified technician.
14