Whirlpool WGD7540FW0 Manual de instrucciones de instalación - Página 14

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Secadora Whirlpool WGD7540FW0. Whirlpool WGD7540FW0 25 páginas. Gas dryer/canadian electric dryer

Imprimir página

Attach long hose to dryer fill valve

and tighten coupling

Remove protective cap from

water inlet valve. Attach other end

of long hose to fill valve at bottom of dryer

back panel. Screw on coupling by hand until it is seated on

fill valve connector. Using pliers, tighten the couplings an

additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling

can result.

Turn on cold water faucet

Check that the water faucets are turned on.

Check for leaks

Check for leaks around "Y" connector, faucet, and hoses.

CONNECT VENT

Connect vent to exhaust outlet

Using a 4" (102 mm) clamp, connect vent to exhaust outlet

in dryer. If connecting to existing vent, make sure vent is

clean. Dryer vent must fit over dryer exhaust outlet and inside

exhaust hood. Check that vent is secured to exhaust hood

with a 4" (102 mm) clamp.

Move dryer to final location

Move dryer to final location, taking care not to crush or

kink vent or flexible gas line.

After dryer is in place, remove corner posts and cardboard

from under dryer.