Whirlpool WHDSCX80112 Manual de referencia - Página 3

Navegue en línea o descargue pdf Manual de referencia para Secadora Whirlpool WHDSCX80112. Whirlpool WHDSCX80112 8 páginas.

Imprimir página

Turn the knob to select the desired drying time. Confirm it

by pressing the knob.

Set dryness level, if needed

If you want to change the dryness level, make sure that the

Dryness level button « lights up.

Turn the knob to select the desired dryness level, then press

the knob to confirm.

Select options, if needed

If you want to select additional options, make sure that the

Options button « lights up. The options which are selectable

for your programme are indicated by lighting arrows.

Turn the knob to select the desired options. The symbol of

the selected option will blink. To confirm it, press the knob.

Some options / functions can be selected by directly

pressing the button.

Refer to section OPTIONS, FUNCTIONS AND

INDICATORS for more information.

INDIVIDUAL MODE

After you have switched on the dryer, you are not forced to

follow the GUIDED MODE.

It is up to you which order you choose to set your

programme. To do a setting, first press the relevant button,

then turn the knob to select, and finally press the knob to

confirm.

The variety of options and dryness levels depends on the

programme selected. Therefore it is recommended to start

your setting with selecting the programme.

START PROGRAMME

Press and hold Start/Pause « until the button lights up

solidly; the drying process starts.

The duration can be recalculated and adapted in the course

of the programme.

During such phases, an animation occurs on the display.

CHANGE THE SETTINGS OF A RUNNING

PROGRAMME, IF NEEDED

You can still change some settings after a programme was

started:

• Adjust drying time (only if programme Drying time is

selected)

• Add or cancel an option, provided the progress of the

programme still allows it.

Press the relevant button. The selected setting will blink for

a few seconds.

While blinking, you can adjust the setting by turning the

knob. If the value or setting stopped blinking, press the

button again.

Press the knob to confirm the modification. If you do not

confirm, the modification will be confirmed automatically

— the modified setting will stop blinking.

The programme will continue automatically.

To change the settings of a running programme or start

delay, you can also:

• press Start/Pause to put the running programme on pause

• change your settings

• press Start/Pause again to continue the programme.

RESET A RUNNING PROGRAMME, IF NEEDED

Press and hold the On/Off button « until "rES" appears on

the display.

The programme is ended afterwards.

Immediately open the door and unload the laundry, so that

eventual heat in the laundry can dissipate.

SWITCH OFF THE DRYER AFTER PROGRAMME END

At the end of the programme, „End" appears on the

display. Press On/Off « to switch off the dryer. Open the

door and take out your laundry.

The dryer will switch off automatically in about a quarter of

an hour after programme end, to save energy.

EMPTY WATER TANK / CLEAN DOOR FILTER /

CLEAN BOTTOM FILTER

Refer to section CARE AND MAINTENANCE.